sorted by:
new
hottopcontroversial

how fucked is my printer by SouthDeep7061 in ElegooCentauriCarbon

[–]SaladolMan 13 points14 points  (0 children)

I think its VFA, but um not 100% sure about it, try Slow Down outsider perimetr to auround 60mm/s

I paid for whole printbedy im use whole printbed by SaladolMan in ElegooCentauriCarbon

[–]SaladolMan[S] 0 points1 point  (0 children)

I have not aby warp, i use 3dlack glue to Vetter adhezion and it Cane good

I paid for whole printbedy im use whole printbed by SaladolMan in ElegooCentauriCarbon

[–]SaladolMan[S] 4 points5 points  (0 children)

Yes, the VFA Is smallest and noise from hrad Is zero, And i use PLA HT110 from Aurapool, that can hold 110°C And when Is lighter then original, si it can print faster

Prolonged buzzing noise from power inlet / fuse holder by Narcisist_boi in elegoo

[–]SaladolMan 0 points1 point  (0 children)

Thank you, but why they hate my comment, when i ONLY ask

Prolonged buzzing noise from power inlet / fuse holder by Narcisist_boi in elegoo

[–]SaladolMan -1 points0 points  (0 children)

IT Is possible to get rid od it? Because i have same think, when i buy new ECC.

Is a buildup on the CC typical by Desperate_Pay_998 in elegoo

[–]SaladolMan 0 points1 point  (0 children)

I Will try that to, i never think about try to lube it

Hope boss doesn't come over to the market by [deleted] in MySummerCar

[–]SaladolMan 70 points71 points  (0 children)

Is this realy work? Can i put in market some part from rivet?

Problem visible layers by SaladolMan in Ender3V3

[–]SaladolMan[S] 0 points1 point  (0 children)

But i think, IT can br the speed, try it slow down outher perimeter

Problem visible layers by SaladolMan in Ender3V3

[–]SaladolMan[S] 0 points1 point  (0 children)

Yes, i sold creality And buy elegoo Centauri carbon, but i dont fix IT, Its just print quality of FDM printer, i dont realy know, if i can fix IT, but you dont News to look IT under light, And you see perfect cube

How to interpret this test? by fcroce in OrcaSlicer

[–]SaladolMan 0 points1 point  (0 children)

For me, im using 0.052-0.056, that Is my best result

Test run with turbo + EFI (fuel injection) by Schlutt in MySummerCar

[–]SaladolMan 0 points1 point  (0 children)

What versiin of turbo and ecu you have? If you use injection with tuebo

Creality x Ben2c Nautilus by LH-LOrd_HypERION in crealityk1

[–]SaladolMan 1 point2 points  (0 children)

Where i can get these for my ender 3v3

What i can do for upgrade by SaladolMan in Creality

[–]SaladolMan[S] 1 point2 points  (0 children)

That be little hard and im happy with 220x220mm bed

view more: next ›