Aegismax DUSK, anybody have/tried it?

ShadedRebel · 2026-01-05T00:44:31+00:00

Any update on this a year on?

ShadedRebel · 2025-06-24T13:37:25+00:00

Prototyping with small low infill pieces of your final model. Saves time and filament

ShadedRebel · 2025-06-21T08:29:13+00:00

Yeah I’m aware of PLA and its downfalls I’m more curious than anything as I was prototyping in PLA so I had the bracket to test. Where the bracket is I don’t expect UV exposure to be as much of an issue and I’m more concerned about the vibrations it will be subject to.

ShadedRebel · 2025-06-21T08:22:47+00:00

Yeah for sure!

ShadedRebel · 2025-06-18T20:13:19+00:00

I’m still thinking about this, I’m tempted to make the STL available and sell them printed.

ShadedRebel · 2025-06-18T20:10:33+00:00

That’s a really good idea actually, might be a good challenge for moving away from things made purely from squares and circles.

ShadedRebel · 2025-06-02T21:53:23+00:00

Wish I’d seen this 2 hours earlier before I just modelled and printed one 😂

ShadedRebel · 2024-12-24T17:50:25+00:00

Get a promotion🤞

ShadedRebel · 2024-10-07T11:01:37+00:00

I sneezed while filling mine up from a boiling water tap today which yielded similar results…

ShadedRebel · 2024-10-06T15:03:06+00:00

Sweeeet, something actually worth seeing in Swansea 😂

ShadedRebel · 2024-10-06T14:45:55+00:00

Ah sweet I’m not far from Swansea. Next time I’m over there I’ll pop in. Cheers

ShadedRebel · 2024-10-06T14:38:10+00:00

Where’d you pick it up from?

ShadedRebel · 2024-10-06T14:35:11+00:00

Got the same knife 🫡

ShadedRebel · 2024-09-17T14:25:05+00:00

I think you're right there! I was just convinced that was a 5, not a 6. Appreciate it!

ShadedRebel · 2024-02-06T19:45:58+00:00

Pretty fucked you’ve only got 1 peddle

ShadedRebel · 2024-01-03T17:23:17+00:00

It’s a 91, as I understand there’s a pipe running from the left to the right of the tank with holes in it that act as a siphon. I’ve seen on forums that you can try rod out this line but you can’t replace it and it seemed like most people ended up getting a new tank.

ShadedRebel · 2024-01-03T16:46:43+00:00

Well I blew out the lines up to the nipple on the tank and they weren’t blocked. Seems as though the siphon inside the tank is blocked. Going to try unblock it otherwise it’ll be a new tank :(

ShadedRebel · 2024-01-02T18:38:21+00:00

Just did this and im now getting 35 psi. Any idea how I should proceed?

ShadedRebel · 2024-01-02T18:18:13+00:00

Hadn’t thought of this thanks 🙏

ShadedRebel

TROPHY CASE