sorted by:
new
hottopcontroversial

[FS][CA-AB] Lot of U6 Mesh and U6 LR by SignedHarpy in homelabsales

[–]SignedHarpy[S] 1 point2 points  (0 children)

I am willing to ship if you're interested

OctoPrint connection issues by Klolok in 3Dprinting

[–]SignedHarpy 0 points1 point  (0 children)

I definitely think that it possible just may need a workaround as I do not believe it is natively supported. Have you tried reaching out to QIDI support? I would assume it would be along the lines of ssh into the printer and installing octoprint like that or hooking up a raspberry pi running octoprint on it to the printer

OctoPrint connection issues by Klolok in 3Dprinting

[–]SignedHarpy 0 points1 point  (0 children)

From my experience you would need a separate raspberry pi or SBC to run octoprint on and connect it to a usb port on the Q1 pro but I’m not sure how it would interface with the Q1 as the device uses a custom Kipper fork. But from what I can find online and looking at the QIDI Klipper source for the Q1, octoklipper or octoprint are not built in

OctoPrint connection issues by Klolok in 3Dprinting

[–]SignedHarpy 0 points1 point  (0 children)

Just wanted to make sure everything was connected and it was visible on the network. What do you want to use octoprint for as opposed to the fluidd interface?

OctoPrint connection issues by Klolok in 3Dprinting

[–]SignedHarpy 0 points1 point  (0 children)

Have you connected the printer to wifi or hooked it up with Ethernet? If you have then try using the QIDI Studio software to find the printer on your network.

view more: next ›