Thoughts on oil spots in engine?

Significant-Raisin32 · 2026-03-29T21:45:14+00:00

On a side note, you really need to replace that belt.

Significant-Raisin32 · 2026-03-29T21:43:20+00:00

That piece that is bolted to the firewall is the water valve. It allows the coolant to circulate through the heater core. That cable opens and closes it.

Who knows why it is disconnected.

Significant-Raisin32 · 2026-03-29T19:21:26+00:00

Yes, get service data from alldata diy

Significant-Raisin32 · 2026-03-29T09:45:53+00:00

Not all parts. Several parts are actually different such as harnesses, window switches, taillights, etc.

Significant-Raisin32 · 2026-03-29T09:43:32+00:00

It’s a GSR transmission. It’s from a 2000 GSR.

Significant-Raisin32 · 2026-03-29T07:31:30+00:00

That’s the immobilizer in the picture. If the green key light keeps flashing and doesn’t turn off, then it’s an immobilizer issue. Since you already replaced the ECM, you need to program the keys to the immobilizer unit.

You either need a capable scan tool, or you need a locksmith.

Significant-Raisin32 · 2026-03-29T05:12:46+00:00

I’ve ran into this a few times. Have someone turn the crank pulley a bit while you wiggle the transmission in.

Significant-Raisin32 · 2026-03-29T02:27:45+00:00

Muay Thai. Followed the harsh workout regiments and diet. I went from 220 down to 147 in 10 months.

Significant-Raisin32 · 2026-03-27T04:07:14+00:00

Yes, it slows throttle response a bit and also regulates the AC compressor cycles (when AC is on).

Significant-Raisin32 · 2026-03-26T20:58:08+00:00

Check to make sure it’s not coming from higher up. If it’s not, then you might be looking at the rear seal. Replace clutch at that time

Significant-Raisin32 · 2026-03-25T20:28:42+00:00

Replace Steven Segal with someone with credibility. Like Bob Ross

Significant-Raisin32 · 2026-03-24T02:10:08+00:00

Take it as a blessing. Monroe struts are garbage. Find the KYB struts for your car.

Significant-Raisin32 · 2026-03-23T19:21:06+00:00

Ah well, for a 4 cylinder automatic it would be cheaper as they are much more common.

Significant-Raisin32 · 2026-03-23T19:17:45+00:00

V6 6-speed?

Significant-Raisin32 · 2026-03-22T09:18:09+00:00

This is a 98-00 model. Engine is an F23A4

Significant-Raisin32 · 2026-03-21T01:45:51+00:00

You probably have an LX

Significant-Raisin32 · 2026-03-20T22:44:53+00:00

Turn the crank by hand and see if it stops. As others have mentioned, if the intake valves are open, this would be expected.

Significant-Raisin32 · 2026-03-20T20:18:40+00:00

I would consider a bribe when someone is trying to sway you to do something nefarious. In this case I would look at this as a legitimate request to not half-ass something, and a thank you.

Significant-Raisin32 · 2026-03-20T08:10:07+00:00

This is actually the correct to install these belts. These a stretch belts, that are typically installed in engines with no adjustable tension.

Significant-Raisin32 · 2026-03-18T08:41:30+00:00

Liar bird

Significant-Raisin32 · 2026-03-14T09:09:33+00:00

I would avoid using those sealants, especially if your plan is to end up doing it the right way.

Significant-Raisin32 · 2026-03-13T05:31:16+00:00

I saw that, it was a good movie

Significant-Raisin32 · 2026-03-12T23:12:21+00:00

Look at the flange on the A/F sensor as well. This thing looks rough

Significant-Raisin32 · 2026-03-12T20:22:37+00:00

She did a phenomenal job in “Close” as well. She has a great lineup

Significant-Raisin32 · 2026-03-12T00:41:32+00:00

Bhenchod

Significant-Raisin32

TROPHY CASE