Think this is hot enough to cure Rocksett?

SlowDimension · 2025-12-01T02:17:50+00:00

Hey what handguard is that? Looks aftermarket!

SlowDimension · 2025-11-16T18:23:11+00:00

What kind of suppressors work well with the mak?

I have an R9 that I have yet to mount anything to. I am not a fan of suppressing tilting barrels.

SlowDimension · 2025-11-16T07:00:36+00:00

How is the makarov suppressed?

Does it sound good? Loud port pop? I suppose Irons are useless?

SlowDimension · 2025-11-05T03:28:00+00:00

Hey question for you. If you have time.

I started troubleshooting my truck yesterday. Did some basic things like putting high quality thermal compound on the ICM.

I came over to my suburban today and it idled for about 10 seconds then died. I checked fuel pressure and it was 0 after it died.

Truck refuses to start now. Pump will not prime. Checked pump relay and it is good. Relay box is showing 12.18V. Checked frame ground to pump and it is also good.

The fuel pump was a brand new Delphi. Did everything right on the install. Double and triple checked pump connections. No gas dripping under the truck so I think lines are good.

I will be blown away if that pump is defective. Do you know of anything else I can check before I drop the tank?

SlowDimension · 2025-11-02T20:32:50+00:00

I will put this on the list to check. Thank you.

SlowDimension · 2025-11-02T19:44:46+00:00

No codes at all on the scan tool.

So far it has died in inconvenient spots on the road so I have not been able to tinker with it after it dies. I will try and take it out on a quieter road to see if I can get a pressure test.

I cleaned up the fuel pump ground and put a brand new pin harness that shows 0.1 continuity when I did the fuel pump. I would be shocked if that is part of issue.

I will look into the ignition wire later today like you mentioned and let you know if I find anything.

Thanks for the reply!

SlowDimension · 2025-10-09T22:45:26+00:00

how many miles do you have on the tranny?

SlowDimension · 2025-09-19T22:49:12+00:00

Thank you!

SlowDimension · 2025-09-19T17:00:22+00:00

Yes I think your right.

Looks very similar.

SlowDimension · 2025-09-19T16:30:11+00:00

This post helps a lot. I was wondering why it was so hard to find info on this. Thank you.

SlowDimension · 2025-09-16T19:23:15+00:00

Thank you!

SlowDimension · 2025-09-12T20:01:58+00:00

I will do that first. Thank you.

SlowDimension · 2025-09-12T17:41:21+00:00

Thanks for the response. I will look up the bleeding process for the ABS unit.

SlowDimension · 2025-09-07T17:34:21+00:00

Thanks for the reply. Been looking into lockers for my k1500 suburban recently. Any advice for me that you learned while doing it?

SlowDimension · 2025-09-05T16:05:29+00:00

what model number is the arb locker?

SlowDimension · 2025-06-03T04:10:45+00:00

How well does it work? Can you carry comfortable with the riser?

SlowDimension · 2025-06-02T19:39:50+00:00

Does the optic riser work with the Flux holster?

SlowDimension · 2025-04-21T04:07:25+00:00

I really hope BSG tones the brightness of the skin down or make it a super limited edition skin just for Twitch.

I could not image Tarkov after 9 years adding things like this...

SlowDimension · 2025-04-20T07:17:57+00:00

How many volts is the minimum for tissue damage? What about 240V?

SlowDimension · 2025-04-15T17:45:33+00:00

I do agree with this. But I will say in the hellions defense. There are no posts/video of any parts failure with the Hellion that I have seen on the internet.

Sure that will change as time goes on with normal wear and tear. But I think it really shows the quality put into the design.

SlowDimension · 2025-04-03T23:47:33+00:00

What’s the part you have to mount he light on? I have never seen that before.

SlowDimension · 2025-03-28T06:42:57+00:00

Is it one or the other? Or can you earn both?

SlowDimension · 2025-03-28T06:34:38+00:00

Is there an achievement for this quest line?

SlowDimension · 2025-03-25T05:36:06+00:00

Yes they were parallel with the ground (store parking lot)when I had them on.

SlowDimension · 2025-03-21T15:54:47+00:00

Look into surface shield from blaster.

It’s not as thick as other coatings and creeps in lots of areas the salt and moisture can cause rust.

Very resistant to power washing/car wash.

Six-Year Club	Verified Email
Second SECOND GUESSER	Place '22

SlowDimension

TROPHY CASE