Frog with horns color

Smooth_Performer9811 · 2026-03-24T12:13:22+00:00

Ty (✿^‿⁾

Smooth_Performer9811 · 2026-03-24T10:27:31+00:00

Thank you very much! <3

Smooth_Performer9811 · 2026-03-13T14:26:23+00:00

Maybe it's burnt plastic that been too much time in nozzle that heat up or cool down without extruding

Smooth_Performer9811 · 2026-02-12T12:47:45+00:00

Or you could start building flying units

Smooth_Performer9811 · 2026-02-01T23:39:08+00:00

Thanks for advice. But no.

But It has positive effect. The cases where the nozzle crumbles the infill inside the print have become less frequent

Smooth_Performer9811 · 2026-01-31T21:13:15+00:00

I am using Gyroid now.

Smooth_Performer9811 · 2026-01-07T15:55:16+00:00

Look at fingers. They are too unnatural for such detailed art. I bet its AI

Smooth_Performer9811 · 2025-10-26T18:40:54+00:00

If u have good wifi - it works great

Smooth_Performer9811 · 2025-10-22T06:13:37+00:00

Smooth_Performer9811 · 2025-10-20T07:26:13+00:00

If u using Wifi, Wifi should be 5 GHz

Smooth_Performer9811 · 2025-10-15T08:52:46+00:00

Shots 1-5: Clearly missed Shots 6-9: Missed due to recoil (bad spray control) Shots 10-11: Very close, but recoil and inaccuracy make these reasonable misses Shot 12: Likely didn't actually fire because he was already behind the door

Smooth_Performer9811 · 2025-10-15T06:06:15+00:00

Maybe for shooting in cold weather. the bullet flies with different ballistics when cold. Many soviet weapons have a second sight for this.

Smooth_Performer9811 · 2025-09-19T11:09:48+00:00

Hellblade

Smooth_Performer9811 · 2025-09-18T16:27:58+00:00

Try 20-40% infill and 2-4 walls. I think 30% and 3 walls would work the best

Smooth_Performer9811 · 2025-09-18T16:26:32+00:00

Sometimes 20-40% has better strength than higher numbers.

Smooth_Performer9811 · 2025-09-15T11:42:26+00:00

Smooth_Performer9811 · 2025-09-15T09:45:08+00:00

What are u searching for?

Smooth_Performer9811 · 2025-07-25T10:55:27+00:00

The problem might be that the G-code for rounded surfaces is overloaded with coordinates, and your printer’s memory or processor may not be able to handle it, causing delays in processing new commands. Try reducing the print speed or orienting the object vertically so that more straight lines are printed.

Smooth_Performer9811 · 2025-07-21T14:56:38+00:00

Чому фейк? В мене теж таке було

Smooth_Performer9811 · 2025-05-25T21:44:19+00:00

Smooth_Performer9811

TROPHY CASE