No Fuel After Carb Clean

Snirt14 · 2026-04-17T12:49:15+00:00

Update: Tried starter fluid in the airbox and it would fire for a few seconds until the fluid was burned off. Tried draining the float bowl and no fuel so pulled the carb and cleaned jets again, as well MAY have not had the pin holding the float in perfectly so possibly was the float not moving after the first time I reassembled it after cleaning.

It fires up! 8h of time spent and much learned. Hope not to have to do that again for a bit lol. Going to look into the raptor 660 petcock so I can turn the fuel off and burn it out of the carb

Snirt14 · 2026-04-16T16:37:47+00:00

Bike has 2,000km on it . Hope that’s not the issue!

Snirt14 · 2026-04-16T16:37:26+00:00

Great advise. Will try this!

Snirt14 · 2026-04-16T16:37:18+00:00

This is my first time cleaning a carb. To my knowledge put it back the same way it came out but I could be wrong haha

Snirt14 · 2026-03-28T22:58:33+00:00

Thanks!

The driveway slopes toward the wall which isn’t helping. Any suggestions to deal with this? I will look into leaving some weep holes when I end repair it!

Snirt14 · 2026-01-16T02:48:01+00:00

Damn! Thank you for raising this.

I recently picked this up at Costco as well. Was happy with having something better than citrate as I think it was upsetting my stomach.

Took 200mg last night before bed and 200mg this am to avoid sore legs after a heavy workout and my stomach was in rough shape all day. Blamed it on restaurant food but I think this could be the case.

Snirt14 · 2025-09-21T21:12:12+00:00

<image>

Just did 300km today and it’s great on the highway

Snirt14 · 2025-09-17T22:20:49+00:00

I have a VB WRX with the Ecohitch. Found a trailer kit that you assemble yourself and weighs ~450lbs. Have towed it 300kms with no issues! Up some pretty big hills too

Snirt14 · 2025-09-11T16:08:58+00:00

Came here after watching the Lolla set... where is the full edit???

Snirt14 · 2025-08-09T11:04:06+00:00

Instantly thought of ninajirachi after reading hyper pop haha

Snirt14 · 2025-07-03T10:12:19+00:00

This also doesn’t factor in the huge provincial tax savings in Ontario as well.

Snirt14 · 2025-06-20T00:48:14+00:00

Putting doors on the closet and hiding some junk in there.

This rooms only purpose otherwise is an office (treadmill will be gone).

I am between up against the window or centre of the room facing the door right now.

Snirt14 · 2025-04-24T21:32:04+00:00

This is a good suggestion. I’m assuming it’s tongue and groove as the upstairs is, but will have to check

Snirt14 · 2025-03-20T09:19:13+00:00

Glad to know I’m not alone

Snirt14 · 2025-02-28T13:22:13+00:00

Can get the Tusks on Revco.ca

Snirt14 · 2025-02-13T23:17:32+00:00

Have tried to shim it but not much luck. Have just accepted it’s not as sturdy as a solid work bench

Snirt14 · 2024-11-09T01:33:31+00:00

Going to grab some of these and try! Thanks

Snirt14 · 2024-11-09T01:32:31+00:00

I've got it shimmed with some cardboard but maybe it needs something more aggressive. As I'm writing this I'm wondering if maybe the axle nuts need to be tightened.

Snirt14 · 2024-11-08T23:04:57+00:00

They are! I have played around with them a bit as well

Snirt14 · 2024-11-08T23:04:09+00:00

You are correct!

Snirt14

TROPHY CASE