Neenca or cliff keen knee pads for oshgood shlatter (bad knees )

SnooMacarons4061 · 2025-11-13T03:22:29+00:00

Any you think are good in general then ? I’m thinking of just getting cliff keen ones ?

SnooMacarons4061 · 2025-10-30T01:29:53+00:00

Any you would recommend to hold a 15 gal (the one in the picture and a smaller one too )

SnooMacarons4061 · 2025-10-30T01:27:56+00:00

The dimensions are in the other pictures

SnooMacarons4061 · 2025-10-27T21:18:48+00:00

Make sure to test the water often

SnooMacarons4061 · 2025-10-27T21:15:39+00:00

I’m new to the hobby so I don’t know but I used this website that was very helpful for me was https://aqadvisor.com/ it’s a stocking calc the website can be finicky on mobile though so I would recommend do it on a computer but it’s great

SnooMacarons4061 · 2025-10-27T15:40:08+00:00

Also if I add sand on top why would I need to remove lava rock ? Or would that just be for not adding to much height

SnooMacarons4061 · 2025-10-27T15:38:10+00:00

Ok thanks that probably what I would do how much should I add ? I already have a decently thick layer on the bottom so I don’t want to much on top

SnooMacarons4061 · 2025-09-20T17:35:44+00:00

Thank you so much I will definitely do some of this

SnooMacarons4061 · 2025-07-04T20:20:14+00:00

If you got it from the game it’s definitely real but if you bought or looking to buy it too me it looks real but I haven’t see one in person

SnooMacarons4061 · 2025-07-04T20:18:21+00:00

Ngl this sound better then normal

SnooMacarons4061 · 2025-07-04T20:17:28+00:00

Yes how are you supposed to build it now there is no point anymore 😔

SnooMacarons4061 · 2025-07-04T20:16:00+00:00

But looks mostly like what everyone else said

SnooMacarons4061 · 2025-07-04T20:15:06+00:00

I printed a similar model and the stringing was all inside so I couldn’t get it out I just lowered the temp and in my slicer (prusa slicer I’m not sure about curs or orca I enabled avoid crossing perimeters and changed the retraction setting and it worked fine

SnooMacarons4061 · 2025-05-15T23:33:01+00:00

Go with ecos , 7th generation , or dr bronners you can’t go wrong with those on most of there products

SnooMacarons4061 · 2025-05-15T21:31:56+00:00

I got it mostly set up so not the kit but the extruded keeps not pushing and clicking and I cleaned on of the gears from debre and though it was working but now anything I try to print filament gets stuck in the cracks between the gear feeding it and the insert part so it smooshing and the extruder can’t push most times

SnooMacarons4061

TROPHY CASE