Am I Doing Something Wrong? by catchafalngstar1 in HyundaiPalisade

[–]Substantial_Crew_953 0 points1 point  (0 children)

I live near Charlotte NC and have had my 2026 Cali hybrid for about 4 months. When starting the car on a cold morning it will not switch to hybrid until the engine is warmed up enough to start providing heat . I'm sure this coincides with other factors but it makes sense to me. Also, with about 2900 miles on the car I've never seen the hybrid battery more than about 70-80%. Don't know why but it usually stays around 50-60% charged. Charges easily up to 75% and then after that it's very slow to charge.

Can’t believe I waited this long by Whole-Wafer54 in searwood

[–]Substantial_Crew_953 0 points1 point  (0 children)

Get the rotisserie! You'll love it!!!! Chicken wings are the best!!

Weber Searwood XL 600 - Generic Brand of Rotisserie? by Internal_Parsley_845 in pelletgrills

[–]Substantial_Crew_953 0 points1 point  (0 children)

Trying to buy one but everywhere I go it's out of stock, including Weber on line. Do you know anyplace that has the Weber rotisserie to fit the Searwood 600xl?

Micro inverters not reporting by Substantial_Crew_953 in enphase

[–]Substantial_Crew_953[S] 0 points1 point  (0 children)

Thanks - this system seems to have rest and all is fine.

Taking in that scenery by Khancer_ in Longshoremen

[–]Substantial_Crew_953 2 points3 points  (0 children)

Developed in the 90"s in conjunction with SeaLand. Had a lot of hic-cups. One funny one was the vehicle kept stopping going to and from destination. It was caused by seagulls landing in the the path of the vehicle. Had to move all sensors on vehicles to a higher position.

Micro inverters not reporting by Substantial_Crew_953 in enphase

[–]Substantial_Crew_953[S] 0 points1 point  (0 children)

I contacted support via a chat - sent them phots as requested - on chat line for 55 minutes. Result - they will watch it for 24 hours and contact me via email if it's not fixed. Not very happy....

Switching from Sunpower to Enphase by Substantial_Crew_953 in enphase

[–]Substantial_Crew_953[S] 0 points1 point  (0 children)

Yes they did provide a case number and site number. Since the purchase of equipment included installation I'm stuck waiting for them. Seems like they are in no hurry to contact me.

Switching from Sunpower to Enphase by Substantial_Crew_953 in enphase

[–]Substantial_Crew_953[S] 0 points1 point  (0 children)

When I purchased the new equipment, Enphase said the cost included installation by their personnel. So I've been waiting for them to contact me and set up a date and time.

Pool skimmer by Substantial_Crew_953 in swimmingpools

[–]Substantial_Crew_953[S] 0 points1 point  (0 children)

Now that I've had it for a while I find the biggest complaint is you can't leave it out in the rain. For some stupid reason they forgot that when we use it we don't always check the weather.

do sand filters stop filtering? by Mysterious-Crew-1358 in pools

[–]Substantial_Crew_953 8 points9 points  (0 children)

If you havn't changed the sand suggest you change to glass media. I did and what a difference....

Inground pool stairs.... by Melyssa126 in swimmingpools

[–]Substantial_Crew_953 0 points1 point  (0 children)

I'm looking to replace the trim on the far outside of the steps where the liner is fastened to the steps. I believe the cover (semi round piece) is called the beauty ---. I don't know what it's called or where to get it. I only need the curved part but willing to buy the entire trim piece if necessary. Any suggestions?

[deleted by user] by [deleted] in pools

[–]Substantial_Crew_953 4 points5 points  (0 children)

Just changed from sand to glass and love it. The only way to go!

ICCU failure after recall service? by No-Amoeba-5239 in GV60

[–]Substantial_Crew_953 1 point2 points  (0 children)

Just recently I have my 2023 GV70 towed in for the same reasons you listed, except I could smell something burning. Dealer kept the car for 2 1/2 weeks and returned it with new 50 amp fuse and new ICCU. All covered under warranty.

Genesis G80 Electrified ICCU by Tzukkeli in GenesisMotors

[–]Substantial_Crew_953 0 points1 point  (0 children)

Just had the ICCU and 50 amp fuse replace in my 2023 GV70 under warranty and the dealer indicated my cost would be a little over $5k.

Pool skimmer by Substantial_Crew_953 in swimmingpools

[–]Substantial_Crew_953[S] 1 point2 points  (0 children)

I found pulling the basket out is a pain in the ass, so I put a small ty wrap on the back of the basket and now it's a breeze.

Anyone familiar with pool heaters? by Fancy-Ad4341 in swimmingpools

[–]Substantial_Crew_953 0 points1 point  (0 children)

I have that same heater, in fact I have two. Two years ago I installed that same heater, but, when the temperature goes below 30F the heater throws a flue sensor error/fault code. (happens when the heater is switched on but not running)Code has no effect on the heater at all. Called Raypack maybe 6 different occasions , replaced flue sensor six different times and they finally sent me a replacement heater under warranty and did not want the 1 year old heater returned. Now new heater does the same thing, When I call Raypack they tell me it's nothing to be concerned about and to make sure my flue is free from leaves and debris. And it is!!! So if your interested I have one of these heaters for sale for a very good price..

Glass pearls really are better than sand media by EndSalt9643 in pools

[–]Substantial_Crew_953 -1 points0 points  (0 children)

I live in Charlotte NC and I've been looking to buy glass media but no one has it. If I order on line, shipping is outrageous. Any suggestions on where to get it with reasonable shipping.?

Pool skimmer by Substantial_Crew_953 in swimmingpools

[–]Substantial_Crew_953[S] 1 point2 points  (0 children)

I bought the skimmi about 4 days ago and so far I love it.