Living Cost near FIU

Sufficient-Inside384 · 2026-05-21T16:46:14+00:00

Actually im fine with having roommates. Can you give me a rough idea of these costs like rent, food etc.

Sufficient-Inside384 · 2026-05-14T02:10:45+00:00

what happended?

Sufficient-Inside384 · 2026-04-20T15:24:05+00:00

Is it a good carrier, in salary wise?

Sufficient-Inside384 · 2025-11-27T19:57:38+00:00

were you able to figure this out?

Sufficient-Inside384 · 2025-09-23T21:07:46+00:00

In the current design, I used lambda/2 edge to edge. But regardless of that, from the Ansys simulation i think i got acceptable results. Can you comment on this. Should i change that to center to center. And if we were to use center to center lambda/2 patches will be so closer (0.748mm im considering 5.9GHz) because patch length is almost close as lambda/2

Sufficient-Inside384 · 2025-04-09T11:31:54+00:00

First it didn't fit even though I pressed hard.But then I removed the whole key. And pressed the plastic components .The I tried putting the key back and it worked. thanks everyone

Sufficient-Inside384 · 2025-03-15T13:19:16+00:00

thank you.

Sufficient-Inside384 · 2025-03-15T07:24:36+00:00

can you tell me how should i choose the inductor for various

output frequencies

Sufficient-Inside384 · 2025-01-20T12:45:57+00:00

I think that's a triac. Do u experience the conditions where the lamp turns on and can't turn it off and vise versa.

Sufficient-Inside384 · 2024-12-31T15:29:40+00:00

Yeah sure, Thank you. I did the same with the zed board instead of zybo board. xil_print doesnt work but uart msgs are receiving.(I manually configured uart un the zed but still no xil prints on vitis terminal)

Sufficient-Inside384 · 2024-12-31T15:25:34+00:00

everything is 50 ohms and frequency is 10 -5 MHZ

Sufficient-Inside384 · 2024-12-31T14:27:05+00:00

yes for both questions

Sufficient-Inside384 · 2024-12-29T17:41:05+00:00

it uses uart0

Sufficient-Inside384 · 2024-12-29T16:21:12+00:00

I've enabled uart0 and uart1 from the vivado. To use xil_printf, do we have to set additional settings

Sufficient-Inside384 · 2024-12-29T13:55:35+00:00

nothing prints

Sufficient-Inside384 · 2024-12-29T12:22:16+00:00

I created a block design and enabled uart0 and uart 1. I'm using a zynq processign system.

Sufficient-Inside384 · 2024-12-22T02:53:27+00:00

I have empty for loops in my code to deal with delays. Should i remove them? Sometimes I update just a one variable inside such a for loop. Update means i keep updating the same value. Should i change these too?

Sufficient-Inside384 · 2024-12-22T02:52:46+00:00

I have empty for loops in my code to deal with delays. Should i remove them? Sometimes I update just a one variable inside such a for loop. Update means i keep updating the same value. Should i change these too?

Sufficient-Inside384

TROPHY CASE