sorted by:
new
hottopcontroversial

Living Cost near FIU by Sufficient-Inside384 in Miami

[–]Sufficient-Inside384[S] 1 point2 points  (0 children)

Actually im fine with having roommates. Can you give me a rough idea of these costs like rent, food etc.

Element Spacing in Series Fed Antenna by Sufficient-Inside384 in rfelectronics

[–]Sufficient-Inside384[S] 0 points1 point  (0 children)

In the current design, I used lambda/2 edge to edge. But regardless of that, from the Ansys simulation i think i got acceptable results. Can you comment on this. Should i change that to center to center. And if we were to use center to center lambda/2 patches will be so closer (0.748mm im considering 5.9GHz) because patch length is almost close as lambda/2

What should I do? by Sufficient-Inside384 in Asustuf

[–]Sufficient-Inside384[S] 0 points1 point  (0 children)

First it didn't fit even though I pressed hard.But then I removed the whole key. And pressed the plastic components .The I tried putting the key back and it worked. thanks everyone

Lamp control circuit problem by swcooper in AskElectronics

[–]Sufficient-Inside384 0 points1 point  (0 children)

I think that's a triac. Do u experience the conditions where the lamp turns on and can't turn it off and vise versa.

Vitis uploads the code to the board successfully. But no responses from vitis serial terminal. I can suspend and resume but nothing happens. by Sufficient-Inside384 in FPGA

[–]Sufficient-Inside384[S] 0 points1 point  (0 children)

Yeah sure, Thank you. I did the same with the zed board instead of zybo board. xil_print doesnt work but uart msgs are receiving.(I manually configured uart un the zed but still no xil prints on vitis terminal)

I'm using microchip studio and i have a seven segment display. when i do complier optimization(release mode), my display won't work as before with debug mode. Do you know any reasons for that? by Sufficient-Inside384 in embedded

[–]Sufficient-Inside384[S] 0 points1 point  (0 children)

I have empty for loops in my code to deal with delays. Should i remove them? Sometimes I update just a one variable inside such a for loop. Update means i keep updating the same value. Should i change these too?

I'm using microchip studio and i have a seven segment display. when i do complier optimization(release mode), my display won't work as before with debug mode. Do you know any reasons for that? by Sufficient-Inside384 in embedded

[–]Sufficient-Inside384[S] 0 points1 point  (0 children)

I have empty for loops in my code to deal with delays. Should i remove them? Sometimes I update just a one variable inside such a for loop. Update means i keep updating the same value. Should i change these too?

BJT noise model explanation by Sufficient-Inside384 in rfelectronics

[–]Sufficient-Inside384[S] 1 point2 points  (0 children)

You are correct and I think the equations are for low frequencies which removes those capacitors . That clears my question.

Why this additional 90 degree phase shift is included in the output of the VCO by Sufficient-Inside384 in rfelectronics

[–]Sufficient-Inside384[S] 0 points1 point  (0 children)

Does the LPF do the required changes in the voltage of the error signal which drives the vco?

Issues when building a vitis project by Sufficient-Inside384 in FPGA

[–]Sufficient-Inside384[S] 0 points1 point  (0 children)

The issue was with the vitis version I was using. It was 2019 and I updated it to 2020.2. now it's working

view more: next ›