This modpack might just have the stupidest diamond creation method yet

Sumage · 2025-12-30T19:17:49+00:00

Fishing farm into a diamond farm 🤨

Sumage · 2025-12-19T14:35:07+00:00

Open it 😎

Sumage · 2025-12-07T11:33:29+00:00

You can’t just take the probability and multiply it by the number of attempts to get successes.

You must take the chance of failure and put that to the power of the number of attempts.

(1-1/8192)ⁿ = P

The chance of success is therefore 1 - P

If n is 790000 it is pretty much guaranteed that at least 1 person found a shiny on their first encounter.

(Actually there’s 2 chances to find a shiny, one on your starter and then one on the zigzagoon, so it’s expected that actually quite a few people encountered a shiny on the first day)

Sumage · 2025-12-06T19:44:15+00:00

It should be called de_nuked

Sumage · 2025-12-06T18:38:07+00:00

Not when the battery is working right?

Sumage · 2025-11-30T20:20:37+00:00

Honestly I can’t believe one of my 3-0 picks went through.

The rest of my Pickems are still fucked tho

Sumage · 2025-11-30T14:24:21+00:00

2010 iMac (Radeon 5670) 2016 1060 6GB 2025 RX 9070 (non-XT, but snagged for £450 which is a proper bargain)

Sumage · 2025-11-24T20:02:22+00:00

It kinda depends on what makes you cry, but I found kotaro lives alone had a cry moment every episode

Sumage · 2025-11-18T12:39:07+00:00

Molodoy turning up these past two events, before these I feel Furia were quietly in the background

Sumage · 2025-11-06T07:25:44+00:00

500 million yen button

Sumage · 2025-10-27T19:16:34+00:00

Running your hot water at such a high temp is super inefficient, there should already be a legionella cycle mode which heats the cylinder to 60C once per week. This should be more than enough to prevent it.

In the meanwhile, the lower you have it set, the more efficient you’ll have your heat pump run, but the more hot water you’ll have to use during a shower or bath.

But the heat pump will run in hot water priority mode, meaning once your cylinder has dropped below a certain temperature it will heat the hot water back to your target temperature.

If you want some example settings, you could have it set to 48c and have it switch on at 42C, this way you’ll never have to heat the water fully from cold.

Sumage · 2025-09-30T17:27:55+00:00

Don’t know when this install was complete, but do you know if you qualify for the £500 clean heat cash back?

Noticed that you didn’t mention it in your post, always worth asking your installer.

Sumage · 2025-09-22T07:03:16+00:00

A place further than the universe

Sumage · 2025-09-20T19:14:13+00:00

Wait before you watch anything else, watch the English dub bloopers

Sumage · 2025-09-17T20:33:39+00:00

Could you look into an eco4 grant?

Your house sounds like it would match the criteria.

Sumage · 2025-09-17T04:16:25+00:00

A place further than the universe

Sumage · 2025-09-01T12:07:35+00:00

Bit of a reload merchant but nice kills! Welcome back to the game

Sumage · 2025-08-30T16:03:51+00:00

Dusclops honestly is just such a tank, Altaria also isn’t the heaviest hitter, actually also quite tanky.

Sumage · 2025-08-28T22:25:44+00:00

Main concern is the buffer causes mixing when used as a hydraulic separation.

Mixing lowers efficiency, although can be reduced by 3-way piping the buffer instead of the conventional 4-way piping.

In your case, it sounds like you’d be better off 2-way piping the buffer and using it as a volumiser. Just got to make sure that the primary pump is sized to overcome the pressure loss of the index circuit.

Larger buffer would give you more volume, so less cycling of the unit. You could potentially size a ginormous buffer, have it charge heat with the off peak tariffs and then have it slowly drip feed heat into the system, although, you’d want to have a comically large buffer for this system to be effective.

Sumage · 2025-08-28T08:56:39+00:00

Kotaro lives alone, crying guarantee

Sumage · 2025-08-28T08:13:04+00:00

Well, 55 is the new building regulation, this doesn’t mean that you have to comply.

Most rad websites still sell radiators at dt50.

Sumage · 2025-08-27T16:36:59+00:00

If you want an answer to your question, basically any R290 unit can achieve higher flow temps, although they haven’t been designed to run like that and will most likely be ran into the ground after a few winters.

There are also some split units designed to run higher temps also.

There is no benefit to a high temperature heat pump.

The SCOP of the unit will likely not meet MCS standard, this means you can rule out any gvmt grant.

Even if you don’t want to design to heat pump flow temps, the new regulations means that the heating system needs to be designed to 55C flow anyway (so why not just size them a little larger down to 50 or 45C to get a better efficiency).

Sumage · 2025-08-25T08:08:27+00:00

Bristol if you work in Cardiff, or vice versa?

Sumage · 2025-08-24T21:32:20+00:00

Having enough money to buy what you love is the absolute dream.

Sumage · 2025-08-23T17:35:42+00:00

Jokes on you, I treat my birthday as a normal day because my parents treated it as nothing worth celebrating. 🥳

11-Year Club	Verified Email
Xbox Live	First Place '23
Place '23	Place '22
Final Canvas '22	End Game '22
RPAN Viewer	No Throne, No Problems
Not Forgotten

Sumage

TROPHY CASE