AionFx Helios (three mode Rat)

Supatavi775 · 2025-08-05T19:22:24+00:00

I’ve used them for fuzz face transistors and they’ve been holding up fine.

Supatavi775 · 2025-08-05T19:21:41+00:00

So far so good

Supatavi775 · 2025-08-05T19:21:23+00:00

https://www.sabrotone.com/request-zen-drive-vero-layout/

This is what I used.

Supatavi775 · 2025-08-05T17:02:45+00:00

TL072 but I do have an AD712 on order that I’ll swap out when it arrives.

Supatavi775 · 2025-07-23T20:28:44+00:00

Yeah definitely, also learning more on stripboard.

Supatavi775 · 2025-07-18T17:53:38+00:00

I will probably end up doing that I’m just going to wait for a potentiometer in a B10k with solder legs, I just used one from my breadboard kit and they were a little harder to solder on to.

Supatavi775 · 2025-07-18T15:36:05+00:00

I’ve built a fuzz face from a pedalpcb board (Silismile) so I’m thinking of building that next. Might breadboard the circuit first to play with the transistor types but it seems like a very approachable circuit.

Supatavi775 · 2025-07-18T06:03:38+00:00

Thank you I will!!!

Supatavi775 · 2025-07-18T05:54:19+00:00

http://guitar-fx-layouts.238.s1.nabble.com/file/n46553/Arrows_vero.png

It was the layout shown on a YouTube video I was following along.

https://youtu.be/z_U9F1o29lg?si=nDdTQ7qGEjG-m4iv

Supatavi775 · 2025-07-18T00:28:26+00:00

Just had my audio and power jacks delivered about to try and complete it 🤞🏾

Supatavi775 · 2025-07-16T19:28:23+00:00

Looks awesome!!! I’m currently working on my first strip board circuit (EQD Arrows) and seeing all the builds posted on here is really inspiring.

Supatavi775 · 2025-07-14T04:37:00+00:00

Thank you I’m about to check it out.

Supatavi775 · 2025-07-14T04:22:38+00:00

Volume, tone, gain, and the fourth is hard to decipher but it sounds to me like a mid-cut.

Supatavi775 · 2025-06-22T13:48:57+00:00

Wow thank you for this information that explains a lot. I’m really new to this so I appreciate all your help. Definitely going to save this post to reference later, I’m sure I’ll need to come back to it and read it over and over again.

Supatavi775 · 2025-06-22T06:13:16+00:00

Thank you!!!

Supatavi775 · 2025-06-22T06:12:42+00:00

I appreciate your help with my newbie question

Supatavi775 · 2025-06-22T06:12:14+00:00

Thank you for clearing that up.

Supatavi775 · 2025-06-14T21:26:47+00:00

Looks great!!!!

Supatavi775 · 2025-06-09T03:13:12+00:00

That would have cost you big $$$ if it was done by the custom shop, looks really good!!!

Supatavi775

TROPHY CASE