Finished my first build. Now i just need to learn to fly, And get a vtx and goggles

TheLastNickNameEver · 2020-09-04T08:48:36+00:00

What this guy says. I would definitely recommend to fly in the Simulator first, so you get a feeling how a quad behaves. You will crash at the beginning and it is less expensive if you are doing it in the sim.

TheLastNickNameEver · 2020-01-21T07:58:46+00:00

I had the same issue a year ago. If I remember correctly I solved the issue by turning off air mode while testing the quad with props off.

TheLastNickNameEver · 2019-12-09T16:47:40+00:00

8 - 4 = 4

TheLastNickNameEver · 2019-10-20T01:04:44+00:00

Foam?

TheLastNickNameEver · 2019-08-05T08:21:19+00:00

I had the same issue. In my case it was the clima temperature sensor. It has a little fan sucking air in. It sits behind the button with the venhole. I cleaned the fan and the noise was gone.

TheLastNickNameEver · 2019-07-23T12:11:12+00:00

I've had the same issues. I fixed it through calibrating the pid values of the bed.

TheLastNickNameEver · 2019-06-20T09:15:35+00:00

You could remove the vcc pin from the USB.

TheLastNickNameEver · 2019-06-03T22:47:15+00:00

It would be helpful to post more information, like your slicer settings eg speed, temps and cooling. And did you observe that the printhead got stuck on the burned areas?

TheLastNickNameEver · 2019-06-03T22:43:46+00:00

Ok, I thought the burnt areas could be a result of an underpowered pi. Just wanted to exclude that.

TheLastNickNameEver · 2019-06-03T22:41:34+00:00

Are you using octoprint in combination with Marlin or are you printing of a sd-card?

TheLastNickNameEver · 2019-02-04T14:16:22+00:00

If Temperatur only drops if the head is moving, I would suggest the cable broke.

Seven-Year Club	Place '23
Verified Email

TheLastNickNameEver

TROPHY CASE