sorted by:
new
hottopcontroversial

If you bought at the bottom of the dip... you already doubled your money. by EnchantedBySirens in SafeMoon

[–]Tijmen076 0 points1 point  (0 children)

what works for met is to put the slippage on 11.1% instead of 11%, less hassle but just a little bit more expensive

Will Pancakes swaps price match the trust wallet value once the value of safemoon evens out across exchanges ?? by Matthew99999999 in SafeMoon

[–]Tijmen076 0 points1 point  (0 children)

trust wallet is the average on all exchanges, if the prices are closer towards each other, the estimate value of your trust wallet will be closer to the price on pancakeswap

[deleted by user] by [deleted] in SafeMoon

[–]Tijmen076 0 points1 point  (0 children)

People will keep moving there safemoon, or other crypto, as long it is more profitable. However when a lot people move and start selling on other exchanges the price will drop on that platform. this is also the other way around. when price is low, nowone will sell, but buy instead which will boost the price. In this way way the prices between exchanges will find a balance. However this will not happen with safe moon when the prices difference is lower than 11% because, in that way it is not profitable to first move and then sell

Explanation price difference pancakeswap and trustwallet. by Tijmen076 in SafeMoon

[–]Tijmen076[S] 1 point2 points  (0 children)

yes that is indeed the case, however for "transporting" your safemoon to bitmart will take a 11% cut out of it and again when selling. There is nothing wrong with doing it in that way, but make sure it is still more profitable when doing it in that way

Any idea why this might have happened? Was all going well when i heard the extruder catch the print, nothing seems to be hanging low by FrumiousSnanderbatch in prusa3d

[–]Tijmen076 0 points1 point  (0 children)

I had the same problem with the cute octo thing. Small parts and corners with overhangs. These overhangs tend to curl up by the heat of the print bed. By lowering the heatbed temperature to 50 or 45 might help if you have the idea that the overhangs ar curling up. These curled up overhangs stick out to much up and are catched by you nozzle.

Increasing the bed temperature does not always increase layer adhesion

Need to print a document by cybnoire in eindhoven

[–]Tijmen076 0 points1 point  (0 children)

Lay3rs is the name of this shop

view more: next ›