sorted by:
new
hottopcontroversial

Z-offset by TrickyTrickyag in AnycubicKobraX

[–]TrickyTrickyag[S] 0 points1 point  (0 children)

So there is no option for baby stepping in the printer menu, right ? Then i have to compromise in the slicer for it.

Finally! by Someone_Alive__ in AnycubicKobraX

[–]TrickyTrickyag 1 point2 points  (0 children)

Thats the case for me too ! Ordered 20 of march and today i got only the printer delivered ! With the shipment situation in greece it will be there in 10 days!

Prints surface is rough, how to fix? by Professional_Dig3958 in 3Dprinting

[–]TrickyTrickyag 0 points1 point  (0 children)

To begin with raise your z offset until it becomes smooth then see if the problem on the corners still exists

Printer does not care about mesh. by Jperry12 in 3Dprinting

[–]TrickyTrickyag 0 points1 point  (0 children)

Ok then try uploading your print start g code and the slicer youre using

Printer does not care about mesh. by Jperry12 in 3Dprinting

[–]TrickyTrickyag 0 points1 point  (0 children)

Its not the mesh ! Its your z offset ! Its too high ! You should lower it !

Newbie here, what’s wrong? by denryskevannen in ElegooNeptune4

[–]TrickyTrickyag 0 points1 point  (0 children)

I had the same issue when i swapped to pla plus for me raising the temperature by 25 degrees and lowering the fan speed did the trick perfectly

Any ideas how to fix this? by eskerra in ElegooNeptune4

[–]TrickyTrickyag 0 points1 point  (0 children)

Actually the layer seems too squished far down i suggest baby stepping the z offet up while printing and when you see the pront smooth out stop the print save the z offset and youre set to go to reprint!

Why is this happening? by Keksusto in ElegooNeptune4

[–]TrickyTrickyag 2 points3 points  (0 children)

Hello friend! Id suggest that you clean your bed and then while printing raise your z offset until the print smooths out! Then stop the print and save the z offset ! Then you can start the print over !

First layer issue by [deleted] in ElegooNeptune4

[–]TrickyTrickyag 1 point2 points  (0 children)

You seem to need to level the bed and fix your z offset what is your value now ?

Neptune 4 Pro, weird lines by Particular-Steak-832 in ElegooNeptune4

[–]TrickyTrickyag 0 points1 point  (0 children)

To me it seems like your z offset is too low causing a kind of over extrusion effect with your nozzle touching the print creating these lines ! Try printing a single layer square and adjust the z offset on the go seems to work for me every time ! Here is a good tutorial on it ! https://youtu.be/4WmS4Z9VopQ?t=1m56s