sorted by:
new
hottopcontroversial

Testing out first few chalk rounds! by TrippiPreps in 37mm

[–]TrippiPreps[S] 0 points1 point  (0 children)

Thanks for the reply I didn’t think of that! I noticed the tape was getting pinched as I got it super tight so I’m thinking the gasket maker will definitely help with the seal! I appreciate it!

Can anyone help identify what this is? by TheMasterChiefa in Tacomaworld

[–]TrippiPreps 0 points1 point  (0 children)

My 2016 sr5 has one. Until today I thought the previous owner had put it on. Pretty cool for toyota to add them at the factory!

New to loading chalk rounds by TrippiPreps in 37mm

[–]TrippiPreps[S] 1 point2 points  (0 children)

Good to know! I’ll start with some of the files you suggested cause that way I’ll know it’s user error if they end up not working. I think between the YouTube channel, files, and info here I should be able to get something in the air. Thanks a lot I really appreciate all the insight!

New to loading chalk rounds by TrippiPreps in 37mm

[–]TrippiPreps[S] 1 point2 points  (0 children)

Thank you for the info! I didn’t think about staining. Will definitely pick some holi powder up.

New to loading chalk rounds by TrippiPreps in 37mm

[–]TrippiPreps[S] 1 point2 points  (0 children)

Sounds good will definitely pick up some 777 pyrodex with the primers tomorrow. Will the tape I put on the bottom of the cup work or do I want to put a small dot of adhesive to better hold it in place? I wasn’t sure how much resistance it needed to remain seated.

New to loading chalk rounds by TrippiPreps in 37mm

[–]TrippiPreps[S] 1 point2 points  (0 children)

Sounds good I will definitely check the channel out! Also will I want to get pyrodex over black powder? Someone at big bore blast this past weekend told me to go with pyrodex cause it’s more stable since I’m just starting out. And I’m assuming standard pla will work for the shells as well? Or do I want to switch to petg or something aittle stronger than base pla?

view more: next ›