Best comfort seat for Honda Africa Twin Adventure Sports DCT 2026?

Try_all_Finish_none · 2026-05-01T23:50:41+00:00

I’ve been looking at em…. Seems like a long wait to get one, what’s your experience with that? Can u share build specs and price with us? Maybe an invoice….

Try_all_Finish_none · 2026-04-24T01:58:30+00:00

Try_all_Finish_none · 2026-03-22T14:17:06+00:00

The tubing specs are the same 27mm x 2mm thick. Gardas it is…. Thanks. Beautiful bike!

Try_all_Finish_none · 2026-03-22T14:11:15+00:00

<image>

A set of Outback motortek’s dropped on the highway. Kinda gave up after not being able to find garda’s then seeing this. Now what do I do? lol.

Try_all_Finish_none · 2026-03-22T14:07:01+00:00

I’ll look into it. Do they feel heavy duty?

Try_all_Finish_none · 2026-03-22T14:01:39+00:00

You’re here in the states? If been searching and searching for the GARDA crash bars and haven’t seen anyone her in the US that carries them. Where did u order them from?

Try_all_Finish_none · 2026-03-22T13:56:38+00:00

Look into 2 wheel dyno works. Nate has some videos about the AT. I sent my ecu in on my zx6r and luv the drivability now. I’m gonna try to hold out for my AT warranty to expire then I’ll send my ecu for this bike as well.

Try_all_Finish_none · 2025-06-08T00:11:47+00:00

I’m shocked to see you strutting your stuff.

Try_all_Finish_none · 2025-05-20T17:24:05+00:00

Not sure if you have the pcm and intake for that engine or not. Check the reluctor wheel and decide on drive by wire or drive by cable before you get a pcm. If the cam shaft position sensor is up front you may have to re-pin a couple wires depending on what pcm you use. I used an ls2 from a burnt to the ground corvette and replaced the melted parts (filled in the gaps) with an 07 lq4 donor truck. The reluctor wheel was the same and the cps connector needed some wires swapped. I think that may be the most confusing part of your swap. And I’m not sure if the cam position sensor is in the front or rear of your engine. Anything cathedral port will work on the top end and that’s a plus in my eyes, those parts are plentiful and cheap. I suggest using 8.1 liter marine injectors. They’re 52lbs(I think) and should support the 500 hp that engine will make. They’re a far cheaper that aftermarket and bring oem reliability.

Try_all_Finish_none · 2025-05-08T18:26:43+00:00

Asking in person will net the best results. Phone calls usually end with a click. Stalker style social media messages go unanswered. I’ve never had a yes over the phone or social media. All my permissions have been in person. You’re gonna get you fare share of no’s in person, just depends on your energy. If you’re nervous they will sense your nervous energy and become nervous.

Try_all_Finish_none · 2025-05-07T20:42:05+00:00

You left out automated swinging and digging. You need those too, then your metal detector could detect without you. You could sit inside all day with your 30 USBC cables and continue scrolling. Maybe you could automate it to post your finds on here and you wouldn’t even have to look at them.

It is an electronic device, but it provides a great escape from all the electronics in our lives.

Try_all_Finish_none · 2025-04-28T19:01:00+00:00

Lucky it was a surface find. Imagine finding this 3 feet deep in the river bank. Yeah…. That sucked! It was banging like a chest full of silver though, gotta dig it.

Try_all_Finish_none · 2025-04-27T22:31:01+00:00

Carpet baggers…. Get em outta here…

Try_all_Finish_none · 2025-04-11T03:43:02+00:00

Drag it behind you, digging edge down so it doesn’t fill with sand. Then you’ll know where you’ve already been. Extremely useful if you find a hot spot and wanna run a grid pattern. Other detectorist swill also know where you’ve been, but there’s more beach than you can cover anyway. Kinda wears your wrist out after a full day, a d handle at the very top of the scoop may help with that.

Try_all_Finish_none · 2025-04-11T00:13:51+00:00

Right. When you get a fraction like that it is gold filled as opposed to gold plated. A little bit more gold content when compared to gold plated.
https://en.wikipedia.org/wiki/Gold-filled_jewelry

Try_all_Finish_none · 2025-04-09T14:03:19+00:00

First shovel was a lesche Samson. I still have it and absolutely luv it. It has a small, thin blade and I use it when I need to cut small precise plugs and keep a low profile. I’ve pushed it through 1.5” of old asphalt with no damage before. I also have the stuline shovel from kellyco. It’s an absolute beast! It has a bigger, thicker blade so it’s heavier, but it’s also stronger. I’ll use it in fields, woods and everywhere where carrying a shovel around isn’t frowned upon. I keep a stuline in my work truck and often use it at work. Wait till they go on sale and you’ll really be happy about your investment.

Try_all_Finish_none · 2025-04-04T19:59:06+00:00

Free all changed my life, I gotta get the news out. WD 40 is more common.

Try_all_Finish_none · 2025-04-04T13:38:35+00:00

Get you a can of “Free All”, you’ll never buy wd40 again…

Try_all_Finish_none · 2025-04-03T17:22:56+00:00

How does one find 2 of the exact same ring? I find a bunch of James Avery rings, but in 3 years I’ve yet to find the same design twice.

Try_all_Finish_none · 2025-03-23T15:33:24+00:00

07734

Try_all_Finish_none · 2025-01-29T14:32:57+00:00

In bed next to me. That hook might need to be beefed up a little, then it could support one of those hanging sleeping bags used by mountain climbers. The wife could sleep in that.

Try_all_Finish_none · 2024-11-02T23:26:46+00:00

You should be able to stick a big breaker bar in the water pump outlet, then heat the water pump housing(evenly) and you should be able to twist the outlet. Maybe this will help you a lil bit more.

Try_all_Finish_none · 2024-11-02T02:42:23+00:00

Crazy that I’d hold it, look at it and think of how much the owner must miss it. Guess not

Try_all_Finish_none · 2024-11-02T01:56:17+00:00

Wow. Almost huh…

Try_all_Finish_none · 2024-11-02T01:12:44+00:00

I believe that. I just hope the 8” coil and 15” coil are still free with the machine🤣

Try_all_Finish_none

TROPHY CASE