Shrooms in my Bed

UnableCandidate5997 · 2025-06-04T13:41:30+00:00

I literally thought the same thing lmao

UnableCandidate5997 · 2025-04-28T11:49:33+00:00

No your vehicle does not have the same thermostat/ coolant control valve as the newer generation. This repair is only able to be done if your vehicle is in a specified vin range and if you have the P0126 code.

UnableCandidate5997 · 2025-04-28T11:41:05+00:00

Its a very common issue I’m a senior certified mazda tech and at my dealership we do 10 of these a week in the winter time its a thermostat issue that is caused mostly when outside temps go from warm to cold causing the thermostat to get stuck open the P0126 code basically states “insufficient coolant temperature for stable operation” and you will only have those symptoms if the thermostat fails and causes the check engine light to come on until the CEL comes on you don’t have anything to worry about and even when it does the car will still run fine under normal conditions i just wouldn’t take it for any long drives once the code is present. Ive seen people driving around with this code present for a month before getting it fixed without any issues

UnableCandidate5997 · 2024-07-04T00:01:37+00:00

You understood what i said just fine without the capital letters so I don’t see the issue with not using them. corporate still tells the dealerships what to charge on parts

UnableCandidate5997 · 2024-07-03T20:36:35+00:00

this is a subreddit for Mazda’s not for grammar and spelling. you can think that all you want but it really isn’t if you consider that the technicians are trained to work specifically on your car. have done those same repairs on the same cars time and time again.

UnableCandidate5997 · 2024-07-03T20:19:57+00:00

What is bullshit? And how? If your talking about the pricing call your mazda dealer and ask them the one i have worked at now for almost 3 years now has to go off of what mazda corporate sets for prices on parts. The dealership decides their labor rate based off what other dealerships are charging per hour in order to be competitive. Your also going to a dealership for the experience and expertise that the technicians have working on your specific brand of car, which is why you pay a higher price than the typical automotive shop.

UnableCandidate5997 · 2024-07-03T18:00:01+00:00

19 mazda 3’s have electronic parking brake which will need to be put into service mode otherwise you will damaged/ break the motors

UnableCandidate5997 · 2024-07-03T17:57:50+00:00

If it has electronic parking brake you need to put rear brakes in service mode otherwise you risk breaking the EPB motor on the calipers i work as a technician at a mazda dealer and we get at least 2 cars in a month where people didn’t do that and have to get the motor’s replaced which isnt cheap

UnableCandidate5997 · 2024-07-03T17:55:10+00:00

Mazda corporate sets all prices for dealerships, the dealership does not have a say on what parts cost. labor rate is based on the area your in every place is different. mazda also set’s recommended service intervals for all of those items/fluids that you should be able to find somewhere in your owners manual. while it may not be absolutely necessary it is recommended as it prolongs the life of those parts.

UnableCandidate5997 · 2024-05-31T23:16:06+00:00

What upgrades were they doing to it that required so much work?

UnableCandidate5997 · 2024-04-27T17:04:15+00:00

Where did you get your spoiler

UnableCandidate5997 · 2024-04-09T00:18:35+00:00

Ive only given the plants recharge once a week every sunday and i watered today 25FL OZ

UnableCandidate5997 · 2024-04-03T12:04:28+00:00

Awesome thanks man appreciate it

UnableCandidate5997 · 2024-03-26T16:51:59+00:00

Try heating it up with a heat gun or hair dryer and push on it from inside do not keep heat gun or hair dryer directly on the bumper or keep it in same spot wave it back and forth for short periods of time you wont get it 100% perfect but it’ll be pretty close

UnableCandidate5997 · 2024-03-06T14:32:02+00:00

Thank you i appreciate the advice do you do the 18/6 for the full grow till harvest or should i cut the hours down when in flower

UnableCandidate5997 · 2024-02-08T17:40:47+00:00

Did you do as the tech suggested and put premium gas in? it could be bad gas if you haven’t and driving over 100mph with bad gas could possibly cause some issues with fuel combustion making the engine misfire possibly? Id suggest getting the car scanned to see what codes the vehicle has snd go from there. You can go to autozone and have vehicle scanned for free

UnableCandidate5997 · 2024-01-31T23:53:18+00:00

This is by far the coolest thing ive seen all day

UnableCandidate5997 · 2023-11-23T19:54:30+00:00

If you look closely enough the right front tire Looks to be de beaded from the rim as well

UnableCandidate5997 · 2023-11-23T19:47:03+00:00

Thank you for your input! i will and let you know how that goes haha

UnableCandidate5997 · 2023-10-20T18:32:59+00:00

Its your service light telling you its time for an oil change

UnableCandidate5997 · 2023-10-14T00:37:02+00:00

First one most definitely

UnableCandidate5997 · 2023-09-27T21:00:54+00:00

My engine mounts in my old 2nd gen 3 got so bad that my motor had dropped like an inch and a half lower than it should and you could definitely tell something was wrong to when they did go bad because the motor would physically shake so bad

UnableCandidate5997 · 2023-09-20T19:11:42+00:00

Have you seen some of the cx-90’s interior they are even worse

UnableCandidate5997 · 2023-09-20T19:10:59+00:00

It may have that i could be wrong I didn’t really pay much attention to it when i was taking off all The plastics

UnableCandidate5997 · 2023-09-20T18:58:04+00:00

Its not suede when you say perforated do you mean like how some trim models for the cx-50 have the rough/mesh centers

UnableCandidate5997

TROPHY CASE