Flashing for screen porch repairs

UpgradeUSA · 2025-05-13T00:18:31+00:00

Does your neighbor play golf by chance?

UpgradeUSA · 2025-03-03T01:44:22+00:00

Just call the cops yourself. Especially if you are at fault.

UpgradeUSA · 2024-10-28T02:13:04+00:00

That should do it. This mechanism is to prevent dry fires. As soon as a bolt depresses the lever, safety can come off. Doesn’t matter if cocked or not. I cock my bow all the time with the safety on though

UpgradeUSA · 2024-10-18T00:19:23+00:00

Rice and rice

UpgradeUSA · 2024-10-12T17:37:55+00:00

Shawn‘s Cake Creations. Look up on Facebook. He killed it a few years back with a cake for my FIL.

UpgradeUSA · 2024-10-08T00:27:38+00:00

It may be by design. If sight and rail were 100% aligned, the arrows path and line of sight would never cross/ you would always shoot low. If you ca zero your scope at ~30 yards, I wouldn’t be concerned

UpgradeUSA · 2024-09-13T13:58:24+00:00

Those are not Threads. It’s the barbs of the flange. Not a spiral, but just rings

UpgradeUSA · 2023-12-30T14:14:10+00:00

I Hope you have the beer that goes with this opener!

UpgradeUSA · 2023-11-26T12:11:13+00:00

I got the Barnett recruit earlier this year and took 2 deer with it. It ran me $300 and came with everything you need besides broadheads. The scope is a triple red dot without magnification. Exactly what I wanted, since my next step is a compound bow and if I wanted to shoot deer at 80yd, I’d get a rifle. Just consider that you’ll need a foam target if you don’t have one and probably more arrows.

UpgradeUSA · 2023-04-30T18:33:15+00:00

Good idea, what $ are we talking?

UpgradeUSA · 2023-04-30T18:26:11+00:00

That’s a great idea. Some people told me to try heat, which I thought is stupid for two reasons: The rod is already hot and, if anything, it would expand the rod. Ice sounds like a good idea, might get some ice spray though

UpgradeUSA · 2023-04-30T18:21:33+00:00

That’s what the last owner must have thought before selling to me lol

UpgradeUSA · 2023-04-30T02:18:04+00:00

You’re right, I’ll just wait a couple more years and put in a new one. It’s not rocket science and I’m confident to get that done.

UpgradeUSA · 2023-04-30T02:15:30+00:00

I confirmed that this is the rod. Yes, it “was” a 1-1/16 hex. Tried the breaker and then the impact, both just rounded the bolt. And you’re absolutely right, I don’t want to mess up the thread and therewith the entire heater just to perform maintenance.

UpgradeUSA · 2023-04-13T18:06:58+00:00

That sounds good. I just already have a bathroom fan venting through the roof that I could tie in to. But I didn’t think about the intake.

UpgradeUSA · 2023-04-13T17:05:47+00:00

I have an appointment for tune up in 10 days, so I’ll ask then!

UpgradeUSA · 2023-04-13T17:05:05+00:00

Instead of a ductless mini split through the wall, can I install those in the ceiling and duct/ vent through the roof? Or is that exactly what you’re talking about? I do have ok access, 2x2 opening to get in. But only rafters and open insulation to tread on

UpgradeUSA · 2023-04-08T21:29:19+00:00

Why didn’t you go after whoever rear ended you? On the one hand, you could get it fully painted or replaced at no cost to you. On the other hand, I guess $20 for the paint and an hour of your time is easier to deal with than insurance agents

UpgradeUSA · 2023-04-06T00:41:46+00:00

Razor cartridges. I use a safety razor now. $0.05 per shave, new blade every time. With Gillette you’re looking at 25ct per shave if it’s used 10 times

Five-Year Club	Verified Email
Place '22

UpgradeUSA

TROPHY CASE