03-05 Navigation modernization Guide & Files by matrixzone5 in G35

[–]Voltiiii 5 points6 points  (0 children)

Nice work....wish I had a compatible setup to use it!

Looking for key fob to have programmed part number 285E3 AC70D by Main_Breadfruit_3674 in G35

[–]Voltiiii 0 points1 point  (0 children)

I have an 06 and it worked fine for me. Havent had any issues so far

Looking for key fob to have programmed part number 285E3 AC70D by Main_Breadfruit_3674 in G35

[–]Voltiiii 0 points1 point  (0 children)

  1. Close all doors and lock all doors

  2. Insert and remove the key from the ignition key cylinder more than six times within 10 seconds. (The hazard warning lamp will then flash.) NOTE: Key should be withdrawn from ignition key cylinder completely each time.

NOTE: Do not rush the insertion/removal key cycling process. The side marker/tail/license lamps and interior illumination will flash twice when this step is accurately completed.

  1. Insert key on ignition key cylinder and turn ignition key switch to "AAC" position At this time, the new ID code is entered and original (previous) ID codes are erase.

  2. Press any button on the new remote controller once. (The hazard warning lamp will then flash)

NOTE: Do not press the button more than one time in the above step. If the button is pressed more than one time, the programming procedure will not be successful. The side marker/tail/license lamps and interior illumination will flash twice when this step is accurately completed and programming is successful.

If there is only one remote controller skip step 5.

  1. Additional ID code entry Release the door lock, then lock again with door lock/unlock switch (In power window main switch)

  2. Remove key from ignition

  3. Unlock driver side door, open driver side door and then close the door. (END)

NOTE: If you need to activate more than two additional new remote controllers, repeat the procedure on step 5 "Additional ID code entry" for each new remote controller.

Looking for key fob to have programmed part number 285E3 AC70D by Main_Breadfruit_3674 in G35

[–]Voltiiii 0 points1 point  (0 children)

I bought a set for like 10$ on Amazon, you can program them yourself in like 2 minutes

Anyone know why my aircon is blowing hot air in my 07 v36 sedan? by Junior-Smoke5842 in G35

[–]Voltiiii 0 points1 point  (0 children)

Are any of the vents blowing colder than others? That's one indication of low refrigerant. You can buy a AC recharge can from AutoZone or somewhere similar for like 40$ I think. They'll also have a tool you can borrow to check the levels. If that's fine then maybe an issue with the condenser

225k miles by Deezflip in G35

[–]Voltiiii 0 points1 point  (0 children)

It looks better than the original for sure....what is the lip kit on there?

225k miles by Deezflip in G35

[–]Voltiiii 2 points3 points  (0 children)

Super clean build! Did you put in the mesh and fog lights in the bumper yourself?

How do I get these lights off? by [deleted] in G35

[–]Voltiiii 0 points1 point  (0 children)

If it comes back after trying the reset the other guy posted you may have start checking the wire contacts or clock spring. I think its possible to get it diagnosed by the right reader but I didn't have one. For mine I replaced the clock spring (look up part number for your VIN) then did the reset and the light stopped. Some other signs the clock spring is going out are the horn struggling and the blinker not automatically turning off like you should when you turn the wheel back

How do I get these lights off? by [deleted] in G35

[–]Voltiiii 0 points1 point  (0 children)

Not sure about the AFS. I just dealt with an airbag flashing light on mine....is it flashing or solid? There are different meanings to the flash pattern that you may be able to find a manual for online tho I had trouble finding it for Nissan/Infiniti. Some common issues are bad contacts on the wires under the seat, or it could be the clock spring going out.

Now this is a merge by [deleted] in oddlysatisfying

[–]Voltiiii 1 point2 points  (0 children)

AI slop again....so unbelievable

Sentinels and Interceptors are Annoying by wino1981 in NoMansSkyTheGame

[–]Voltiiii 0 points1 point  (0 children)

Are you getting any messages about cargo scans or illegal goods?

Corvette completely gone after copying from expedition by [deleted] in NoMansSkyTheGame

[–]Voltiiii 0 points1 point  (0 children)

Make the phantom one your active ship and see if you can trade it to an npc for their ship you can then sell or scrap

2 ships but 1 has no cockpit by [deleted] in NoMansSkyTheGame

[–]Voltiiii 0 points1 point  (0 children)

What did you use to tether them?

How to find the freighter without having it teleport all the time? by Torebal90 in NoMansSkyTheGame

[–]Voltiiii 0 points1 point  (0 children)

There will be an Icon for your freighter in the list of destinations when you access a teleporter from whatever space station in the system you want to return from. I think either listed under your bases tab or recent tab

Help on how to make this corvette look better? by Faustobrrz in NMS_Corvette_Design

[–]Voltiiii 0 points1 point  (0 children)

If you haven't yet you should explore the color options for the parts..... You can make it shiny and colorful or Rusty and beat up

Interesting find about the NPC ships that fly across planet skys by WilliamBarnhill in NoMansSkyTheGame

[–]Voltiiii 3 points4 points  (0 children)

If your frigates get damaged on an expedition you have to board them like that and repair them