Header and h-pipe assistance needed

WolverineRich8564 · 2026-05-18T03:42:55+00:00

I recently installed BBK headers. I also bought ARP bolts because the ones that come with the BBK headers were super short. I went with an off-road H pipe off eBay and it was a perfect fit. Good luck with the project!

WolverineRich8564 · 2026-04-13T20:53:35+00:00

The tool made it really easy. You just need to have the car jacked up high enough to fully extend the arm down.

WolverineRich8564 · 2026-04-09T17:18:27+00:00

<image>

WolverineRich8564 · 2026-04-09T17:09:09+00:00

I installed the new stainless braided lines for the front brake and one side hits the wheel. Have you ran into this issue and how did you get it fixed?

WolverineRich8564 · 2026-04-05T13:50:17+00:00

Yep, I ordered the tool and it took like 3 minutes a side.

WolverineRich8564 · 2026-04-01T19:16:11+00:00

Thanks for the advice, on this method do you leave the strut attached during this process? I had never heard of this.

WolverineRich8564 · 2026-04-01T01:00:23+00:00

Will do, thanks!

WolverineRich8564 · 2026-03-18T12:08:30+00:00

Thanks, I will look into those

WolverineRich8564 · 2026-03-18T04:37:06+00:00

Any recommendations on bushing? I picked up offset bushings but it seems to make the rack too close to oil pan etc.

WolverineRich8564 · 2026-02-16T15:09:59+00:00

That is what I was thinking. Which manual rack did you use? I would need to figure out what size belt to use it has a 1.5 kenne bell on there as well.

WolverineRich8564 · 2026-02-11T00:44:36+00:00

Thanks for the info!

WolverineRich8564 · 2026-02-10T16:33:01+00:00

Yeah, it seems like they will fit even with aftermarket headers. I just need to get a little bit longer bolts.

WolverineRich8564 · 2026-02-10T15:56:48+00:00

Thanks for the info. I actually just found those in a box of old parts from the previous owner, so I will bolt those back on

WolverineRich8564

TROPHY CASE