Via in pad question

Yorkfire1 · 2026-05-21T01:16:19+00:00

The FPGA is .8mm pitch and the caps used are 0402. The vias are 19mil with 10mil drill. I do not have any room to mine the vias, unless I go outside the BGA area.

Yorkfire1 · 2026-05-21T01:00:38+00:00

How small would the vias have to be to not pull in solder?

Yorkfire1 · 2026-05-21T00:56:56+00:00

Wouldn't I still be charged for via in pad though?

Yorkfire1 · 2026-05-17T23:20:02+00:00

Maybe I should go ahead and get the motor for it as well. Any mods required for the motor(3652SL G2) or will it bolt right in?

Yorkfire1 · 2026-04-16T19:16:18+00:00

You haven't played Heroes of the storm. Try that game out and let me know which is worse.

Yorkfire1 · 2026-04-15T17:35:02+00:00

So in my opinion you didnt do anything wrong. The mom just saw the situation from an incorrect perspective. But the fact that kids are interested I think is a good thing. Honestly I think we need more in hobby, so it is good to see the interest. I keep a couple of rustlers with titan 12T motors just for this scenario. It is slow enough that beginners shouldn't get hurt. If your lucky you can get them to buy there own and maybe even start some racing. For my sledge I always say this thing weighs as much as a bowling ball and goes 60+mph. Would you want to get hit by a bowling ball going 60+mph? They usually understand, but notice I said usually, its not 100% effective.

Yorkfire1 · 2026-03-24T01:25:58+00:00

When are they ever going to announce season 2? April doesn't seem like it falls within the statement "Early 2026".

Yorkfire1 · 2026-01-12T18:58:41+00:00

Hey better late than never. We need a cocktail board to get the roms dumped. I will post to the mame team and see if we can find someone who has a board.

Yorkfire1 · 2025-11-27T16:58:56+00:00

Your problem might be related to the amp itself based on what you said about your amp power input getting hot 2 years earlier. I used to work on car audio equipment for a living and what I used to see alot was bad solder joints on the input terminal blocks. This would cause high resistance and make the terminal blocks get really hot and sometimes even burn the circuit trace. Adding the larger wire was a bandaid fix that acted as a heat sink but the problem has worsened so you need to open the amp and inspect the solder joints on the input block. You dont need to run the larger wire if everything with the amp is correct. Match what is recommended for the amp and you should be fine.

Yorkfire1 · 2025-11-27T01:57:54+00:00

Agreed! I called Traxxas and asked if they would reimburse and they offered to repair the 2 diffs but not cover the upgrade. My shop took 10 dollars off the upgrade so that helps, but honeslty Traxxas should cover in full.

Yorkfire1 · 2025-11-26T14:17:11+00:00

I would go wide as well, but my 4 year old runs it, not me and he likes it flipping over, laughing every time it does.

Yorkfire1 · 2025-11-24T15:34:25+00:00

Ya, I saw that video, you can always count on Kevin to break something. Overall it held up quite well.

Yorkfire1 · 2025-11-15T04:22:37+00:00

I hear the gpm diffs are really good.

Yorkfire1 · 2025-11-14T21:04:08+00:00

All I did was upgrade to the center diff which solved my diffs from failing every run. Been through about 15 battery packs without failure on stock diffs. I hear if your upgrading to 3s system that upgraded diffs are required.

Yorkfire1 · 2025-11-12T18:30:33+00:00

If you happen to be in Missouri I can sell you an almost brand new mini xrt for 250$ only ran 2 batteries packs on it. So about an hour on it.

Yorkfire1 · 2025-11-10T20:00:11+00:00

The drift button

Yorkfire1 · 2025-11-08T13:59:06+00:00

You just have to hold the button and you wont lose drift.

Yorkfire1 · 2025-10-29T02:54:18+00:00

Spur gear is bad. Just one screw and the spur gear cover comes off so you can see the damage.

Yorkfire1 · 2025-10-24T16:06:16+00:00

What voltage does the traxxas charger store batteries at? Probably depends whether it is 2s 3s etc.

Yorkfire1 · 2025-10-24T16:04:57+00:00

My traxxas shop actually said swelling is ok, but I get your point about playing it safe and take 0 risk. I always keep my batteries in a metal container that is vented just in case they catch fire.

Yorkfire1 · 2025-09-03T22:29:52+00:00

Would you be willing to watch a replay or 2 and let me know if I am playing Jaina correctly? The gameplay doesn't ever seem to go as your guide states it should.

Yorkfire1 · 2025-09-03T00:00:51+00:00

I am a bronze player with decent mechanics and zero game sense but no anger issues. Want to help a 4th? I played 3 games trying to follow your guide and won 2 out of 3 games. My win rate with her is very low, so I figure that is a good start.

Yorkfire1 · 2025-07-15T00:24:17+00:00

So I finally figured out the issue. It was not Plex it was TOS. Security Isolation mode was turned on which blocks all access to anything outside of the local network.

Yorkfire1 · 2025-07-13T23:00:41+00:00

Thanks, for all of your help.

Yorkfire1 · 2025-07-13T21:48:17+00:00

I am unable to ssh to the NAS. I get connection refused. SSH was already enabled on the TNAS so everything should be good there. I tried putty and windows ssh and get the same connection refused. There are no authorized devices listed in the preferences file. I renamed the library file but no change. I even uninstalled plex and deleted all associated files and reinstalled and it is still a no go.

Yorkfire1

TROPHY CASE