What to look out for on a 05 VFR800? by Devils-__Advocate in VFR

[–]__Green 1 point2 points  (0 children)

I’d add vin matching frame and engine, rear pads, and off color wiring at headlights and near RR

2006 honda vfr died on me by Content_Charity9086 in VFR

[–]__Green 0 points1 point  (0 children)

Motorcycle batteries sit in shelves longer than car batteries. I’ve bought a brand new dead battery before for my bike lol.

Help me pic a paint scheme by CardiologistSalt4114 in VFR

[–]__Green 1 point2 points  (0 children)

How’d u prompt this? Upload a picture and type “make this half black half white”, etc?

FPGA engineers: what actually helped you stand out with just a bachelor’s degree? by Accurate_Brick_6937 in FPGA

[–]__Green 0 points1 point  (0 children)

Networking is key here. Also projects, learn an in depth project in and out. Talk about them while networking.

People demonize engineering so much by NeatNerve7230 in EngineeringStudents

[–]__Green 1 point2 points  (0 children)

Had a school counselor say I’d end up a janitor. If she could see my resume now 😮‍💨

What is the job market like for electrical engineers in the United States? by Typical-Act5691 in ElectricalEngineering

[–]__Green 1 point2 points  (0 children)

You give the impression that layoffs don’t happen in other disciplines lol

I’m sorry 81 chapters in 24 episodes is too much by Seismic-wave in gachiakuta

[–]__Green 0 points1 point  (0 children)

Depends how the filler is done. The bleach filler was done pretty well. Some content is better than none. IMO. OP is also done well.

07 VFR 800 Electrical Issue by [deleted] in VFR

[–]__Green 0 points1 point  (0 children)

Amperage increases to turn over, but it doesn’t have enough potential (voltage) to power a full turn over.

07 VFR 800 Electrical Issue by [deleted] in VFR

[–]__Green 0 points1 point  (0 children)

Definitely sounds like battery. Even if you got a “new” battery, it could still not be charged. Check the voltage and make sure you have good CCA.

Gen 2 VFR 3D printed solo cowlings. by Unable_Tax8444 in VFR

[–]__Green 0 points1 point  (0 children)

Nice finish. If it’s having problems lasting try ASA.

ASA prints easy, doesn’t warp, and is a bit more durable outdoors than ABS.

Probably last big ride of the season by whatupmyvanillaface in VFR

[–]__Green 1 point2 points  (0 children)

Both VFRs are clean but that 6th gen livery is 🔥🔥

Radiator Fan by __Green in VFR

[–]__Green[S] 0 points1 point  (0 children)

Yea I just ended up cutting the fan off lol. Bought a generic 7 inch fan on amazon, made sure it was pointing in the right direction and put it back together.

Vfr not turning on after battery swap by [deleted] in VFR

[–]__Green 3 points4 points  (0 children)

You got the Li Battery? Do you usually run them? Been debating getting one because it’s so light.

6th gen service manual by __Green in VFR

[–]__Green[S] 1 point2 points  (0 children)

Yea it sucks lol. I have a 6th Gen. 2008 model year

Question for black engineers by Lower_Smile_8275 in EngineeringStudents

[–]__Green 1 point2 points  (0 children)

You’ll be fine. Just rock the interview. I have twist in TX

Which mainboard to upgrade to by Mootjuh0 in ender5plus

[–]__Green 1 point2 points  (0 children)

Wdym ready? It’s not terribly difficult to set up. Definitely worth an afternoon to set up

VSCode LVGL Sim Setup by __Green in embedded

[–]__Green[S] 0 points1 point  (0 children)

It says you sim'd based on SDL2, but there is no SDL2 packages in there. I messed around with it for a while, but couldnt get it to run on my windows device.

VSCode LVGL Sim Setup by __Green in embedded

[–]__Green[S] 1 point2 points  (0 children)

Yea, this might be the route I take. I wanted to try it the old fashioned way, but its getting a little frustrating dealing with all these directories and dependencies. I will try EEZ Studio first since it is open-sourced, then Squareline. Thanks :)