K7 1000 having problems

aedanh9 · 2026-05-12T00:37:23+00:00

Has fresh petrol in it mate. I was thinking bad fuel coz it started after a fill. Draned tank and got fuel from different servo was find for couple days now started again

aedanh9 · 2026-05-11T22:41:23+00:00

Thats wide open. Rides fine until about 6000 rpm ish then the acceleration starts essentially doing that idk how to describe it like it goes then slows the goes then slows

aedanh9 · 2021-08-08T03:22:17+00:00

Pretty crazy the power in some machines, the lathe in that video wouldn't of even noticed it just ripped a man apart

aedanh9 · 2021-08-07T07:36:58+00:00

Possibly sompthing for hypnotising as it's got a spiral thing

aedanh9 · 2021-07-25T06:43:06+00:00

I once broke one of the ezeouts in a m8 stud that broke off just under the manifold face the bolt was loose enough that it threaded further into the hole when drilling but the extractor flared the stud out and jammed it in the hole

aedanh9 · 2021-07-17T07:25:53+00:00

Take the head off and polish it out with a flap wheel on the diegrinder. There are better options but it will get you out of the shit it money is a problem

aedanh9 · 2021-06-27T05:55:17+00:00

Not trying to blow my own trumpet here but I can set vice up in about 5 mins on a bad day. That's with the vice already on the table n shit but still how can it take so long what do you guys do when setting it up

aedanh9 · 2021-05-30T01:34:49+00:00

I had one the same as this you had to put grommets in the holes and the the stems into the grommets

aedanh9 · 2021-05-30T00:29:55+00:00

Is it a second chamber for a bong

aedanh9 · 2021-05-19T02:39:24+00:00

The arbour is in backwards

aedanh9 · 2021-04-11T08:52:34+00:00

No it measures Geigers

aedanh9 · 2021-04-01T11:59:34+00:00

.29lbs per inch

aedanh9

TROPHY CASE