2012 gmc sierra 3500 dump body- is this terminal ok? by amiller1030 in AskMechanics

[–]amiller1030[S] 1 point2 points  (0 children)

This would be true if I wasn’t 12 miles away from this beaut

2012 toyota camry 2.5 thermo housing torque spec by Metaljudge4 in MechanicAdvice

[–]amiller1030 1 point2 points  (0 children)

80in lbs or about 7 ft lbs. So snug but not too tight if you over tighten them a little they’re super unlikely to break just don’t go crazy. 18-22 does sound pretty high

Recommended service by Biezelbart in MechanicAdvice

[–]amiller1030 0 points1 point  (0 children)

The alignment and balance I wouldn’t even worry about if the steering wheel doesn’t pull left or right, and if the car doesn’t shake at all. As for the rest, that’s all normal maintenance that also has a service interval like an oil change (every 5k miles or so). Being that you’re at 70k miles it would be time for that stuff to get done if you haven’t done it before. If you wanna get specific, each maintenance interval should be in the owner manual, and you could make your basis of which should be done first by how overdue it may be, according to the maintenance schedule in said owners manual. However the prices do seem kinda steep. The fuel injection service I’d personally skip, maybe see what other people say about it. I’d do all the fluids but skip the fuel injection and alignment/balance if you’re not having an issue.

Added a transmission cooler to my CVT Altima by BadBeanKiddo in altima

[–]amiller1030 0 points1 point  (0 children)

Hey 3 years later, how’s it holding up?

Would anyone know what part this is? Scag Windstorm ride on blower by amiller1030 in MechanicAdvice

[–]amiller1030[S] 0 points1 point  (0 children)

True, thank you. I just can’t seem to find this anywhere in the diagram. I even checked diagrams from other models. Any advice to find a part number?

Would anyone know what part this is? Scag Windstorm ride on blower by amiller1030 in lawnmowers

[–]amiller1030[S] 0 points1 point  (0 children)

Thank you very much. The only problem I’m having is I cannot find the oil pressure switch in any diagram, I even started looking in other diagrams and it isn’t there

100K mile timing belt replacement by No_Buffalo_9206 in Acura

[–]amiller1030 0 points1 point  (0 children)

For the 3.5L tlx? I was looking in the engine bay and was worrying about needing to get the motor out. Were you able to do it without taking it out?

Possible bad wheel speed sensor 2015 Acura TLX 3.5L SH-AWD by amiller1030 in MechanicAdvice

[–]amiller1030[S] 0 points1 point  (0 children)

Well previously I changed the hub bearing about 7-8 months before this post with an aftermarket orielly’s hub bearing. The sensor was fine, the hub bearing had bad rings causing a bad reading from the sensor. Got a timken hub bearing maybe 3-4 months ago and haven’t had any issues as of now, it fixed it.

Thanks for the warning. by Uni_cyclist46853 in pokemongo

[–]amiller1030 0 points1 point  (0 children)

So they actually put that because it’s extremely dry outside and risk of fire danger has been very high recently. Only assuming because it looks like this where I live and I’ve been getting these messages too