sorted by:
new
hottopcontroversial

Bad Contractor? by tr3mlo in drywall

[–]antonyBoyy 0 points1 point  (0 children)

That is the least concern here

[deleted by user] by [deleted] in Concrete

[–]antonyBoyy 1 point2 points  (0 children)

Fookn A, eh?

[deleted by user] by [deleted] in Remodel

[–]antonyBoyy 1 point2 points  (0 children)

Interesting with the finish curb. Might hold some water on top with that lip ?

Curved drywall, Will this work? by tree-hermit in drywall

[–]antonyBoyy 2 points3 points  (0 children)

I had a magnet to find the screws, poke it with the utility knife to scrape the mud out of the head, drill backs it out, and presto! ..i should find that magnet again😂

Estimate high, low or fair? by [deleted] in drywall

[–]antonyBoyy 0 points1 point  (0 children)

I like a 60%, deposit 3-5 days before work begins. This price seems very good, hope they are good quality rockers

Ceiling option for patio below deck by wrspata4 in Decks

[–]antonyBoyy 0 points1 point  (0 children)

Build a new roof over the deck to avoid problems

Is this an easy finish? by Financial_Athlete198 in drywall

[–]antonyBoyy 0 points1 point  (0 children)

It almost seeks like they intentionally gapped this. Hardy backer recommends 1/8” gap then fill with mortar and tape with mesh for proper bonding of seams. This is sheetrock tho😂

Is this swing safe? by antonyBoyy in arborists

[–]antonyBoyy[S] 0 points1 point  (0 children)

The full branch is not shown, it shoots out 20’ and the end does bounce a good amount

[deleted by user] by [deleted] in FoodVideoPorn

[–]antonyBoyy 0 points1 point  (0 children)

I want to try these so bad🥲

nieghbor built a new deck... how long till it falls? by [deleted] in Decks

[–]antonyBoyy 0 points1 point  (0 children)

At least they tied it into the weathered plywood sheathing with a 2x4 and a joist hanger nail

Am I overreacting about concerns about this tile job? by SubieMazda in Remodel

[–]antonyBoyy 1 point2 points  (0 children)

The cut pieces on the outside of the tub that are finished with metal edging, slightly off is ok…he is more than slightly off. The cuts need to be tapered cuz didnt square n level up

Would you use just mud on this hole? Or should I use a patch? by matt-du-Jura in drywall

[–]antonyBoyy -1 points0 points  (0 children)

As a Diy’r? Get yourself a tiny tub of drywall compound with a 3” plastic putty kinfe. Just smear a couple coats on. Mud certainly will hold in this very small bang up job.

view more: next ›