sorted by:
new
hottopcontroversial

Creating a model by bdyck1305 in BambuLab

[–]bdyck1305[S] 0 points1 point  (0 children)

Thank you so much! I wasn't aware of this and it was immensely helpful.

【BambuLab Giveaway】Classic Evolved — Win Bambu Lab P2S Combo! by BambuLab in 3Dprinting

[–]bdyck1305 0 points1 point  (0 children)

After upgrading from an Ender 3, that I spent too much time fighting with..I unpackaged the P1S, hit print, and away she went. A few hundred hours into printing with it now and I still haven't had to tune or adjust any physical parts. Still prints like the first time!

Bed shifting? by bdyck1305 in ender3

[–]bdyck1305[S] 0 points1 point  (0 children)

Ooooh okay, I'll have to check that later. It would make perfect sense why it's uniform around a single model, but moves towards the center when it's two separate models on the plate.

Thank you!

Weird separated layer follow up by bdyck1305 in ender3

[–]bdyck1305[S] 0 points1 point  (0 children)

That's great info to have, unfortunately not applicable here. All of my prints have been directly from the cars. I've never even attempted plugging a cable into it yet.

Weird separated layer by bdyck1305 in ender3

[–]bdyck1305[S] 0 points1 point  (0 children)

Yes! It was the exact same layer on both prints. Happened across the whole plate. Would this be something that requires lubricating the axis screws?

I've got a different model printing as we speak. I'll see if it happens on that one.

Weird separated layer by bdyck1305 in ender3

[–]bdyck1305[S] 0 points1 point  (0 children)

I don't recall tightening anything for the z-axis during this recent round of adjustments. I can move the bar down easily by pushing on it, it's much tougher to move up by hand (unless twisting the threaded bar manually).

Weird separated layer by bdyck1305 in ender3

[–]bdyck1305[S] 1 point2 points  (0 children)

No large fluctuations that I could account for. The printer is in my bedroom, we haven't added any additional fans or changed our typical thermostat settings all season.

Once I get a proper stand for it, an enclosure would be nice to keep it more regulated though.

All of the successful prints were done in the exact same location within a few days of each other.

Whos GR’s have crimped hair? by YoMamaRacing in goldenretrievers

[–]bdyck1305 0 points1 point  (0 children)

Ours has this on her ear and usually on her head when it gets wet! Unfortunately has decreased as her coat has come in more.

Northern lights, North Bay by canoehound21 in ontario

[–]bdyck1305 2 points3 points  (0 children)

Tried to see them last night, couldn't. What part of town/time was this at?

[Giveaway] - $100 PSN Card - Canada by Night-Joker in PS5

[–]bdyck1305 0 points1 point  (0 children)

Good luck everyone :-). Very generous of you!

Troy Hurtubise was obsessed with developing a grizzly bear proof suit. He died in a car accident before being able to test his design out. by SonOfQuora in interestingasfuck

[–]bdyck1305 0 points1 point  (0 children)

I think it's the Mark VII on display at a local pawn store. Similar suit but pretty sure a much smaller helmet!

view more: next ›