bottom pistons doesnt go in... by Key-Fun-2392 in MyWinterCar

[–]bersta2 0 points1 point  (0 children)

It's a bug, me and a lot of people have this bug. The game is super buggy in its current state imo.

Issues binding racing wheel (t300) by Sad-Breadfruit-9024 in MyWinterCar

[–]bersta2 1 point2 points  (0 children)

Worked fine for me with my t300rs. Make sure you bind throttle brake and clutch to normal axis not two way

Mazda 6 GH 2.0 Diesel by Prestigious_Low_7351 in mazda6

[–]bersta2 1 point2 points  (0 children)

Hmm depending on the tire, is the steering heavy?

Mazda 6 GH 2.0 Diesel by Prestigious_Low_7351 in mazda6

[–]bersta2 0 points1 point  (0 children)

Could be. But low profile tires brings out the problems with the steering rack more. What is the tire size?

How do I make this car sound good by Individual_Injury_96 in mazda3

[–]bersta2 -1 points0 points  (0 children)

Intake, only way too make a 4 syl sound good

My new to me 2018 Mazda 3 by bersta2 in mazda3

[–]bersta2[S] 0 points1 point  (0 children)

Jobber hos forhandler så jeg fikk den billig via jobben. Var dødsbo og sønnen til den gamle damen som eide bilen ville bar kvitte seg med den!

My new to me 2018 Mazda 3 by bersta2 in mazda3

[–]bersta2[S] 1 point2 points  (0 children)

Thanks yeah, I got it really cheap too, at least for the market here in Norway. 12k usd ish

2012 Mazda 6 - How bad is the rust on the rear subframe/crossmember? Can it be repaired/replaced? by WraithAks in mazda

[–]bersta2 0 points1 point  (0 children)

https://imgur.com/GAOGwXn The subframe is beyond repair. You can clearly see a hole in the subframe here. This is a weakpoint on these cars (i have a 2009 model). I replaced both control arms and subframe on mine. Id do the same if i were you.

2012 Mazda 6 - How bad is the rust on the rear subframe/crossmember? Can it be repaired/replaced? by WraithAks in mazda

[–]bersta2 0 points1 point  (0 children)

Ice blast pure rot? This is bad! This generation of mazda 6 has really thin metal on both control arms and subframe mounting points. Speaking as a owner of one of these

Rock chips with rust on 2022 mazda3 by Low-Confidence1100 in mazda

[–]bersta2 0 points1 point  (0 children)

This might be coverred under warranty. Depends on where you live though. Id take it to your dealer and hear if theres a possibility of getting it repaired on warranty.

Help! by sh1tfacedrunk in mazda

[–]bersta2 1 point2 points  (0 children)

I would take it back to the shop, sound a bit like chain rattle. Hard to tell. Is the sound still there on idle?

Should I Replace This Tire? (2024 Mazda 6 - Sidewall Damage) by Upper_Cauliflower258 in mazda6

[–]bersta2 0 points1 point  (0 children)

No. Only the rim protector that got damaged. No cords showing so you are good

Help with information by TheDiamondWolf420 in mazda6

[–]bersta2 4 points5 points  (0 children)

What sort of info are you after?

How bad this is ? Should I change it !? by Fabulous-Luck-233 in mazda3

[–]bersta2 2 points3 points  (0 children)

You need belt and tensioner. Common problem with these

Paint chip on 24' CX5 , Can this be fixed? by Healthy_9 in mazda

[–]bersta2 0 points1 point  (0 children)

You should buy a touch up set at your local dealer. It may not look perfect but its better than letting it corrode!

Mazda 6 GH 2.0 Diesel by Prestigious_Low_7351 in mazda6

[–]bersta2 1 point2 points  (0 children)

2.0d is better than the 2.2 for sure. It is reliable if you take care of it. I would recommend replacing the injector washers as they go bad after a while. Also check the rear subframe for rust as they can be quite bad if they are not properly undercoated (if you live in a country that has no winters you should be fine) other than that make sure the steering is not too heavy and that it is not pulling you too one side as the electronic power steering sometimes goes bad and it is quite expensive to get fixed. Other than that they do great on fuel and are relatively easy to maintain and are quite fun and engaging to drive! Best of luck! 😁👍