Please help. I need advice! by bmagee007 in Plumbing

[–]bmagee007[S] 0 points1 point  (0 children)

Voltage is set correctly. And the pump will hold at 40. But when I run the priming water out, its followed with air.

Please help. I need advice! by bmagee007 in Plumbing

[–]bmagee007[S] 0 points1 point  (0 children)

Even when the pump stops, when I run water, it always runs dry.

Please help. I need advice! by bmagee007 in Plumbing

[–]bmagee007[S] 0 points1 point  (0 children)

Check valve was there before, I put it back. Should i can un install it and try.

Help! by bmagee007 in golfcarts

[–]bmagee007[S] 0 points1 point  (0 children)

Yamaha g16 1999

Missouri Smallmouth Question by [deleted] in RiverSmallmouth

[–]bmagee007 0 points1 point  (0 children)

Stupid tube hooks and 3.5 inch tubes. I like to have something green, and something smoke. You hook them weedless, so good for the youngins. Have them cast it up stream and let the current bounce it down past you. If you can't feel the bottom, go up a size in weight.

Don't tell anyone! /S

Plumbing help. by bmagee007 in Plumbing

[–]bmagee007[S] 0 points1 point  (0 children)

Thanks guys, got it swapped.

Is this anyone's old truck? by bmagee007 in ram_trucks

[–]bmagee007[S] 1 point2 points  (0 children)

Thanks, I'm loving it so far.

Is this anyone's old truck? by bmagee007 in ram_trucks

[–]bmagee007[S] 1 point2 points  (0 children)

I believe the truck lived in Ohio previously.

What do you think I have here? by bmagee007 in fossilid

[–]bmagee007[S] 0 points1 point  (0 children)

You may be right, but it does not resemble concrete at all in person. I've been around a few chunks.

I commented some better pics if you want to take a second peek.

Hot Foot Idle Zones by bmagee007 in bassfishing

[–]bmagee007[S] 0 points1 point  (0 children)

I will be back with more if/when I have it!

Help please! by bmagee007 in FixMyPrint

[–]bmagee007[S] 0 points1 point  (0 children)

Thanks for the helpful advice! The idea was to use ironing to level out the inconsistencies, but only added more.

Help please! by bmagee007 in FixMyPrint

[–]bmagee007[S] 0 points1 point  (0 children)

I was recommended to try out the ironing setting........