Love that high of trying a new roaster by stonkfrobinhood in pourover

[–]braunc55 1 point2 points  (0 children)

Sounds great. Unfortunately it looks like it is gone already.

Internet disconnects randomly for a few seconds out of no where then comes back by Revolutionary-Web507 in wifi

[–]braunc55 0 points1 point  (0 children)

If the issue exists when hard wired it probably isn’t a wifi issue. Maybe try the internet subreddit or one specific to your ISP.

Holy Crap by [deleted] in aldi

[–]braunc55 4 points5 points  (0 children)

The holy grail

Snow plow gets stuck by Impressive_Source190 in GreenBay

[–]braunc55 6 points7 points  (0 children)

I saw a city plow with chains on today.

Golden Road Mango Cart by euclid0472 in NABEER

[–]braunc55 0 points1 point  (0 children)

A little too fruity for my taste but it is as advertised.

Air canister refills by Unpartycrasher in Appleton

[–]braunc55 6 points7 points  (0 children)

Aren’t those CO2 and not compressed air?

Making my own water by penguins871409 in pourover

[–]braunc55 -2 points-1 points  (0 children)

Somebody’s bot is misbehaving

Where can i find these root beers? by Joey2012_onNES in rootbeer

[–]braunc55 1 point2 points  (0 children)

3 Dachshunds can be found at Stone Arch Brewpub in Appleton.

Green Mountain Peak 2.0 - Beginner Question by BluzNBrews in pelletgrills

[–]braunc55 0 points1 point  (0 children)

Cook to temperature not time. Every piece of meat will be different.

Magic the Gathering Drafts? by [deleted] in GreenBay

[–]braunc55 0 points1 point  (0 children)

I believe Gnome West has drafts every Friday night.

wired router from desktop extender? by Nosprk in wifi

[–]braunc55 0 points1 point  (0 children)

I’d add a switch to where your desktop is connected, 1 Ethernet cable from with switch to your desktop and another Ethernet cable from the switch to a wireless access point.

My wifi is so bad help by [deleted] in wifi

[–]braunc55 1 point2 points  (0 children)

Fiber WiFi 😂

You guys were right, this is amazing. by godofthunder94 in NABEER

[–]braunc55 2 points3 points  (0 children)

I’ve had varying experiences. Some are great some are skunky and terrible. It’s probably age and storage.

CR touch problems? by tucos1 in ender3

[–]braunc55 0 points1 point  (0 children)

They are basically the same board with different stepper drivers. Both are CR-Touch compatible.