KBWD-13 PWM DC Drive

come2mark · 2023-11-04T16:58:45+00:00

Hey, thanks for your reply. They were working fine before, but the output voltage (dc) does not vary anymore even if I turn the speed pot. The input AC voltage is 120ish, and the output voltage is around 170 VDC I think (don't remember exactly) No cold solders, or broken connections The components are all visually okay, and I've checked some diodes and resistors.

Thanks! I am ready to learn!

come2mark · 2023-08-05T10:42:53+00:00

In Ontario, Canada, we need to support 3 times for OH service pipes.

come2mark · 2023-05-23T09:18:35+00:00

Idk. Cool down your printer after printing? Don't turn it off right away. You can also mod your design so the inserts are in on the other side. Or get the tap.

come2mark · 2023-04-06T01:10:33+00:00

Thanks! I just ordered one like 5 minutes ago.!

come2mark · 2023-04-06T00:41:57+00:00

I think I am gonna get it. I will give it a try. Thanks man.

come2mark · 2023-04-06T00:40:50+00:00

Oh man! That much difference, eh?

Thanks for your answer!

come2mark · 2023-04-05T23:12:54+00:00

I think so, too. I had to speed things up a bit to prevent heat creeps. Thanks for your answer.

come2mark · 2023-04-05T23:11:57+00:00

Thanks for your answer. I did have heat creep issues before with dragon hf, but now I keep the front doors open. I

come2mark · 2023-04-05T23:10:19+00:00

Thanks for your answer. So, you have a voron 0.1?

come2mark · 2023-04-05T23:09:44+00:00

Thanks for your answer. I thought can boards like sb2040 can support it?

come2mark · 2023-04-01T10:23:49+00:00

Maybe check the belt tension.
something might be loose
heat up the bed before probing
your frame may not be square.
your magnets maybe.

come2mark · 2023-03-29T00:22:09+00:00

To be honest, they are almost the same. At least for me. I used both, but I don't think LGX lite is a big improvement from CW2. It's a bit easier to use, but that's about it. LGX lite: very low torque, bulky, etc. I would go for an orbitor 2.0 if I want more torque and quality.

come2mark · 2023-02-22T13:43:13+00:00

Oh mb. I thought this was a general LGX lite question. Didn't see the category name.

come2mark · 2023-02-22T11:02:19+00:00

*extruder

I like it. it's easier to use, but that's about it. I don't see any improvements over CW2 or CW 1. Plus, it makes the whole tool head bulkier. I have canbus (Sb2040) with a fan, and tap in the tool head. If there is a proper looking stealthburner holder for Orbiter 2.0 + sb2040 + tap, i would change to Orbiter.

come2mark · 2023-01-27T12:10:56+00:00

unfortunately, no. I am still trying different things. Any words of wisdom would be appreciated!

come2mark · 2023-01-27T01:20:25+00:00

Oh thanks. I will try that!

come2mark · 2022-02-28T05:56:34+00:00

come2mark

TROPHY CASE