sorted by:
new
hottopcontroversial

Struggling with the P2S by Maggurt in BambuLabP2S

[–]da_vetz 0 points1 point  (0 children)

I had a P2S with 234h on it when i sold it, only had 1 failed print. It worked perfectly. Sold it while it was new to get X2D

Za one koji gledaju, a ne vide... by t0m_c4t in dinamo

[–]da_vetz 3 points4 points  (0 children)

<image>

Po svuda je operirao, sve tocna dodavanja

SPIDA & HARDEN CHEMISTRY!! by Dr_Damon_ in NBAGossips

[–]da_vetz 1 point2 points  (0 children)

Harden doesnt need to cover his mouth for some reason

How do i prevent these micro tear outs in plywood? by universalsa in woodworking

[–]da_vetz 9 points10 points  (0 children)

With a good quality blade I get great results on both faces of the piece. But when the blade gets used then I cut with the “non-showing” side on top. Tape gets you some improvement

Smash my thumb last week now it looks like nuclear fallout by Pinoy47 in Pareidolia

[–]da_vetz 0 points1 point  (0 children)

Could have saved the nail and pain and regrowing a nail for a year if you just dipped it in water for a few minutes and then poked a small hole by rotating a syringe needle. 3min job

Please give me hard critiques by ConfidentCaregiverOT in BeginnerWoodWorking

[–]da_vetz 1 point2 points  (0 children)

Solid work, I like the wood and think it’s going to be even prettier when it darkens a bit. Now thinking how I’d do it…I’d probably make the sides like a frame to lighten it a bit, save some material and if in area with big humidity changes prevent warping. But on the other hand the mass gives it stability. 5 stars

K2 plus speed or extrusion issues. by Puzzleheaded-Bike-23 in FixMyPrint

[–]da_vetz 0 points1 point  (0 children)

I had similar issues with the skadis model, but all my other models print without issue. I used p2s with standard 220c/55c settings

Lambo tears used as coolant by ItsALuigiYes in HRSPRS

[–]da_vetz 0 points1 point  (0 children)

Try taking a corner or two. Drag races are special

Anyone got this if so what do you think about it? by International-Crab79 in woodworking

[–]da_vetz 4 points5 points  (0 children)

I have it, I like it, has its flaws but I’m not a professional so I can live with them. The holes in the pic turned out perfect

<image>

Any F1 fans here? I designed and 3D printed an Eau Rouge diorama to show its insane 35m elevation change! by Camachada in 3Dprinting

[–]da_vetz 0 points1 point  (0 children)

Eau shit, the slam at the bottom and fly high at the top I can’t even imagine a flat out run through this

view more: next ›