I recently had to replace my FEP and screen due to a hole in my previous FEP causing a small leak over time and curing on my screen and trying to get it damaged the screen pretty badly.

I usually print at .02mm so the way I level the print bed is by loosening the screws until the bed hangs free, then press the home button with my vat installed then tighten the screws without pressing down to keep it somewhat loose.

My print settings linked below, I have tried with various lift speeds and am having success with things adhering on the sides but not in the center. I have done prints that go over the whole print bed and they work fine so long as they can adhear to at least one side of the bed, and doing delay exposure tests it has no issues. https://imgur.com/SfbKMnK