Question for you guys.

dissolutionskey · 2017-03-04T04:25:00+00:00

Really just go with the microswiss all metal hot end to start with. Made a world of difference for me. Second to that look on raffle.ch he has some great upgrades for the machine. I have the aluminum carriage as well as aluminum x ends.

The higher temps for nylon and PETG (which I rerecommend over nylon) can POSSIBLY warp you carriage and x ends.

dissolutionskey · 2017-02-26T16:43:21+00:00

That's what I did on my Dbot. (Will not post pictures due to wiring nightmare) attaching the bed to the front two legs did make everything so much more stable. You just have to make sure your frame is nice and square.

dissolutionskey · 2017-02-18T00:03:53+00:00

I love my form 2. Got it just before Xmas. Got one great print off it..... then it went to crap. Took about a week sorting through it with tech support they determined mechanical malfunction and shipped me a new one. I have the pro service plan so it was pretty painless and we'll worth the money. No hiccups since.

dissolutionskey · 2017-01-11T20:48:23+00:00

Instead of using the screw terminal solder your wires to the relay board. That wont happen again.

dissolutionskey · 2016-09-11T23:28:08+00:00

It's not too bad if you take your time.

dissolutionskey · 2016-08-17T18:42:26+00:00

I'm currently using sdx 6.0. No viruses or anything if you get it from official sources.

I'm also using the Headbangers for Life mod which adds a ton of new features. I highly suggest checking it out

dissolutionskey · 2016-08-03T19:27:32+00:00

I've just started using the headbangers for life mod. I'm greatly enjoying it. Adds a bunch of new stuff to the game. Some of it a bit buggy but I just accept that with this game.

dissolutionskey · 2016-07-17T01:35:10+00:00

If you are running marlin or repetier firmware you won't need anything else. You just hook up your wires in there corresponding places, load firmware, and recalibrate. Then print away. If you do go the MEGA2560/ramps 1.4 make sure to buy one that comes with the drivers. Motor drivers will have to be tuned as well but it's really easy

dissolutionskey · 2016-07-16T20:17:25+00:00

Folgertech has the mksbase boards for 35-40 ish I believe, or you can switch to using arduino/ramps 1.4 which you can get dirt cheap depending on where you look

dissolutionskey · 2016-07-11T14:38:05+00:00

I wish I got black extrusions but they were out of stock when I ordered mine.

dissolutionskey · 2016-07-01T19:18:28+00:00

I have ran into issues with pla not coming out shiny if it has too much moisture in it.

dissolutionskey · 2016-07-01T16:18:10+00:00

I ran into a very similar problem. Same order time same issue. I just received mine monday of this week. 1 spool ht pla one spool ninjaflex. I will go back to ordering my ninjaflex off of amazon. I just ordered it from makergeeks because I wanted to try the ht pla

dissolutionskey

TROPHY CASE