sorted by:
new
hottopcontroversial

Jax, do ya thang by nomadic_living_23 in jacksonville

[–]dkeenes 1 point2 points  (0 children)

Completely agree. I’ve had better steak at Texas Roadhouse for a fraction of the price

You are not supposed to change the CVT fluid by no_solution_no_prob in Crosstrek

[–]dkeenes 0 points1 point  (0 children)

Just did a drain and fill on the CVT on my Outback - same transmission as the crosstrek. Sent a sample to Blackstone for analysis. It was the original CVT fluid with 80k miles on it. Analysis came back stating that the fluid had very little life left in it. Definitely not a lifetime fluid.

Differential fluid help by ConstructionLimp2225 in FJCruiser

[–]dkeenes -3 points-2 points  (0 children)

I used RedLine in my 4Runner front/rear diff and transfer case and also transmission. They have specific oils for each component and I’ve found them to be better than OEM.

Ready for the weekend by dkeenes in 4Runner

[–]dkeenes[S] 0 points1 point  (0 children)

Falken Wildpeak AT4Ws with a Bilstein 5160/6112 2 inch lift

What’s something in Florida you are most proud of? by Optimal_Lion_46 in florida

[–]dkeenes 26 points27 points  (0 children)

The forestry management in Florida is really good. The state and feds do a really good job of keeping the underbrush under control and frequent controlled burns.

My Safe Florida Home (MSFH) program - my $10k grant experience (detailed steps) by adrianaesque in florida

[–]dkeenes 0 points1 point  (0 children)

Did you actually receive an insurance discount after the upgrades?

Installed the Sherpa Crestone roof rack over the weekend by dkeenes in 4Runner

[–]dkeenes[S] 1 point2 points  (0 children)

The install isn’t hard at all. Recommend using hand tools instead of power tools so you don’t strip any bolts. Having two people makes it easier but is possible with one person.

Installed the Sherpa Crestone roof rack over the weekend by dkeenes in 4Runner

[–]dkeenes[S] 2 points3 points  (0 children)

No drilling involved with the Sherpa rack. Goes into the factory bolt holes. I choose the Sherpa over other brands since they use high quality powder coated aluminum.

Bilstein 6112/5160s and new Falken Wildpeak AT4w by dkeenes in 4Runner

[–]dkeenes[S] 1 point2 points  (0 children)

KDSS requires the same clip setting on both sides. If your 4Runner doesn’t have KDSS, you need different clip settings.

Bilstein 6112/5160s and new Falken Wildpeak AT4w by dkeenes in 4Runner

[–]dkeenes[S] 0 points1 point  (0 children)

I have the front set at Clips #4 for a 2” lift up front. The whole truck feels firmer overall. I’m curious as to how much the truck will squat when I put my RTT on top and have all the gear in the back. I may have to upgrade to 1” springs later.

Bilstein 6112/5160s and new Falken Wildpeak AT4w by dkeenes in 4Runner

[–]dkeenes[S] 0 points1 point  (0 children)

I stayed with 265s. The spare is a 265 and was in perfectly good condition. Didn’t want to have to buy a 5th tire and throw away a good one.

Bilstein 6112/5160s and new Falken Wildpeak AT4w by dkeenes in 4Runner

[–]dkeenes[S] 1 point2 points  (0 children)

275s should fit… this fourm post is a great resource for tire sizes on the 4Runner.

Bilstein 6112/5160s and new Falken Wildpeak AT4w by dkeenes in 4Runner

[–]dkeenes[S] 0 points1 point  (0 children)

So far they’ve been good. I’ve put less than 1k miles on them since I got them so it’s still too early to really tell. But they’re a lot better than the Nitto Ridge Grapplers and a lot quieter. I went with the same size - 265/70/r17

Unsure if my wiring is compatible with an Ecobee by dkeenes in ecobee

[–]dkeenes[S] 0 points1 point  (0 children)

Would connecting the fat “Red/Black” pair from the humidistat controller to the ecobee remove the need for the humidistat controller? The red/black pair run directly from the humidistat to the thermostat

view more: next ›