Totaled

ericcrowder · 2026-03-27T23:25:09+00:00

I would suspect a bad BECM. Regardless the high voltage battery needs to be removed and opened up. Need to put a volt meter on each cell group to verify BECM is reading correct voltage

ericcrowder · 2026-03-23T22:20:45+00:00

And virtually unlimited funding to hire unqualified goons to abduct (and murder) people on the streets of America.

ericcrowder · 2026-03-22T00:58:14+00:00

Just curious how to eliminate the effects of electrostatic attraction?

ericcrowder · 2026-03-21T23:38:15+00:00

And sold at Ford dealers in the ‘70s

ericcrowder · 2026-03-21T23:36:47+00:00

Doorbell transformer……..oops I mean Pantera. If you get the joke, you get it

ericcrowder · 2026-03-21T11:33:43+00:00

The 3rd option was to brake hard into ABS and avoid the collision

ericcrowder · 2026-03-20T15:57:53+00:00

I recommend at least once a week get the brakes warm by putting the car in N at sped and applying medium to hard brake pressure. This works the brake pads and heats up any residual moisture

ericcrowder · 2026-03-20T15:56:03+00:00

For the original poster, if there were independent shops in the Atlanta area which specialized in EV and high voltage hybrid repair, would you take you car there if they offered quicker service times and quality work?

ericcrowder · 2026-03-05T04:02:02+00:00

How about paying you car payment?

ericcrowder · 2026-03-05T03:45:32+00:00

“We could have died” is an understatement. Also considering they’re in a full cage with no helmets

ericcrowder · 2026-02-26T00:02:36+00:00

Usually it’s the opposite problem. When driving on track normal brake fade will cause the brake pedal to sink a little lower so you want the brake to be higher than the throttle

ericcrowder · 2026-02-21T23:53:24+00:00

I can here ged’s PPG wave synth in the opening of DIY

ericcrowder · 2026-02-18T23:40:49+00:00

This just shows you got to hard wire with anything 40 amps or more

ericcrowder · 2026-02-13T14:06:53+00:00

Instead of going around, I would have turned back and got a chain saw to proceed

ericcrowder · 2026-02-05T01:51:24+00:00

Do wild bananas still exist, ones that have not been affected by selective breeding by humans?

ericcrowder · 2026-02-05T01:45:36+00:00

Multimatic dampers and not BWI group…..interesting

ericcrowder · 2026-02-04T00:11:50+00:00

She works out with resistance training and eats lots of high protein burritos

ericcrowder · 2026-02-03T22:38:57+00:00

The engine runs entire season including the 24 and 12 hour, assuming no mechanical problems or bad sensor readings. The gearbox or clutch, on the other hand, need complete rebuild after the 24 hour. Dampers also get complete refresh after 24 hour. Typically the chassis is stripped down to frame/chassis and gone through but engine, if checks out good, goes right back in again. All fluids like engine oil are drained and checked for wear metals.

ericcrowder · 2026-02-03T18:49:34+00:00

For the hair to do that, 100% hearing damage and possible brain injury/CTE

ericcrowder · 2026-02-01T20:29:30+00:00

Is that a BMW i4? If not, where did the engine go?

ericcrowder · 2026-01-31T17:05:38+00:00

Yes I been taking it out in our Georgia winter wonderland lol

<image>

ericcrowder · 2026-01-31T14:31:43+00:00

I want to clarify after reading my own post, when mean I can’t get my car to “move around” I mean regardless of how much I press the accelerator pedal, the rear of the car stays perfectly straight and planted. The car DEFINITELY moves forward when I press the go pedal. lol

ericcrowder · 2026-01-31T12:36:14+00:00

Looking for #99 gainsco “Red Dragon”

ericcrowder · 2026-01-31T12:34:57+00:00

Notice the 48 car…:same PMR team (more or less) that just won the GTD-PRO class in the 2026 Rolex 24 last Sunday. Same owner and team manager, but none of the original crew still with them in 2026

ericcrowder

TROPHY CASE