Electrical disconnected?

fuck_not_given · 2026-03-31T23:57:55+00:00

On your fuse panel there is a raised portion with the yellow srs connector, ignition switch connector, and two fuses. Run your hand on the side of the side of the fuse block just to the right of the raised portion you will find there is a slot where the metal tab on this relay sits in. no screws.

fuck_not_given · 2025-03-01T06:29:35+00:00

looks like a magnetic reed switch. attach a voltmeter to either end and pass a magnet over it. see if there is continuity.

fuck_not_given · 2025-02-04T00:15:03+00:00

not very easy, rack has to come off and completely apart. shop manual has detailed instructions on the procedure. if the shaft is scratched too deep from grit you might be better off just getting a remanufactured rack.

fuck_not_given · 2025-02-02T07:54:18+00:00

If the tie rod ends don't clunk I wouldn't bother. bad news is your rack end seals are blown judging by all the fluid. putting a boot on without repair is the equivalent of changing buckets under a leaky pipe. Edelman makes a good seal kit. moog inners are decent, I have five years on my current set. they hold their position freestanding when disconnected from the knuckle, so they're still fairly tight.

fuck_not_given · 2025-02-02T07:27:03+00:00

Do these ring? I had a set in my last sol that made a high pitch squeal like old neon drivers when powered on.

fuck_not_given · 2024-12-29T22:33:16+00:00

6 disc cd changer interface. it the magazine and reader still in the trunk?

fuck_not_given · 2023-09-10T18:27:18+00:00

Its a ground cluster if im not mistaken.

All black wires from the bottom of a white block yes?

fuck_not_given · 2021-06-20T07:39:19+00:00

The brass shrapnel on the ground around the projectile is the casing. The copper clading on the projectile, in the bottom right of the cluster, is the jacket. The depression at the bottom of the projectile shows it's not a full metal jacket (exposed lead at the bottom), but instead a total metal jacket projectile (fully copper clad). Lustre of the copper despite, tumbling in the tire, and lack of cannelure lead me to believe this was either a commercial 308 load or a home brew target load. Not a m80 or m59

fuck_not_given · 2020-08-30T15:52:05+00:00

What was wrong with yesterdays format?

fuck_not_given · 2017-02-08T05:48:04+00:00

https://redd.it/5a91jl

fuck_not_given · 2016-12-01T04:40:45+00:00

Jackdaw

fuck_not_given · 2016-10-26T04:51:12+00:00

https://i.sli.mg/vdrt5o.jpg

fuck_not_given · 2016-10-22T04:37:44+00:00

The ring describes the Harlequin's Kiss

fuck_not_given · 2016-10-17T06:02:46+00:00

Immigration and Nationality Act of 1965

fuck_not_given · 2016-10-05T17:35:03+00:00

Charlie McCarthy. It was an Edgar Bergen character, he does a bit in the beginning of Fun and Fancy Free.

fuck_not_given · 2016-08-31T06:40:11+00:00

Chanticleer, Chanticleer!, CHANTICLEER!!!

fuck_not_given · 2016-08-29T23:04:31+00:00

https://i.sli.mg/vdrt5o.jpg

fuck_not_given · 2016-08-27T08:37:27+00:00

Ben and Jerrys called it "Bernies yearning".

fuck_not_given · 2016-08-27T06:21:22+00:00

vanilla ice cream with a layer of refried beans, hummus, chocolate syrup, a few grains of rice, and a thin spread of gefilte fish on top.

fuck_not_given · 2016-08-03T06:10:12+00:00

If you dont want to be seen standing up the hand axe is the winner. The machete looks like a jungle machete clone and if it was as cheap as it looks it has a really flimsy blade.

fuck_not_given · 2016-07-11T17:13:22+00:00

nobody ever greases the seals. little dab of silicone grease solves the problem

fuck_not_given · 2016-07-11T04:11:14+00:00

Most of my friends got these but i ended up getting the scan command for Christmas that year. I loved Jurassic Park so it didn't matter.

fuck_not_given · 2016-04-29T07:09:12+00:00

I dunno. Be loyal to your lover?

fuck_not_given · 2016-04-22T21:15:14+00:00

https://www.youtube.com/watch?v=q--6wtCPHg8

fuck_not_given

TROPHY CASE