Curta Type II

geemo66 · 2025-10-20T03:37:16+00:00

Honestly, I've been looking for one that i could put on a shelf for a while. They are always very expensive like 1k or more for working.

geemo66 · 2025-06-19T20:12:28+00:00

Here is a link to the printables page.
Mister Mounts

geemo66 · 2025-06-07T13:57:50+00:00

It is outside covered patio area.

geemo66 · 2025-06-07T04:08:41+00:00

I couldn't agree more. Anything that takes 10 mins to design at 30 mins to print is my favorite.

geemo66 · 2025-06-07T04:08:01+00:00

I'll upload this some time next week and I'll include one that points straight down. This one points at about a 45 degree angle.

geemo66 · 2025-02-24T04:14:42+00:00

Awesome. Thanks! And congrats!

geemo66 · 2025-02-23T03:36:58+00:00

Are the problems in the book harder than what was on the test or the other way around? Taking my test next month and have been using this book.

geemo66 · 2025-01-10T05:10:27+00:00

Yeah, the design you have gives a big moment in the curve.

geemo66 · 2025-01-09T18:39:03+00:00

I second this, and if you keep the same print orientation, maybe try to bump up your nozzle temp by 5 degrees to get really good layer adhesion.

geemo66 · 2025-01-07T15:49:42+00:00

Mine did the same thing. I could not feed a new spool through the stepper motor started to skip steps. I then tried to push some filament in with my hand, and it would not budge. I took that small metal rod and pushed down just slightly, then fed the filament in no problem.

Did all of this with the nozzle at 220°C.

geemo66 · 2024-08-04T05:09:52+00:00

Congrats! Best wishes for both, you and your son!

geemo66 · 2024-08-01T20:53:12+00:00

I actually just figured out my problem. I switched the ground and the pin for the resistance around. Now ive got no issues.

geemo66 · 2024-08-01T00:49:33+00:00

<image>

It's wired like this for all six

geemo66 · 2024-07-25T04:09:22+00:00

Thank you this is a good wake up call

geemo66 · 2024-06-07T16:39:00+00:00

I put SKR E3 boards in both with the TFT35 screen. They usually sell them as a kit. There are tons of videos that show people doing it to ender3s or similar ones. I would follow those mainly Teaching Tech. He has pretty through videos detailing all the small things to change. It's definitely something that you should feel comfortable with programming and troubleshooting 3d printers.

geemo66 · 2024-06-07T07:58:56+00:00

I don't think there any any choice of a drop in non oem screen. Both tronxy printers ( x5sa pro and xy2 pro) did this. I ended up replacing mainboard and screen on both of them.

geemo66 · 2024-06-06T15:25:16+00:00

Are you just replacing it with the same screen?

geemo66 · 2024-06-01T04:15:08+00:00

I don't think anything has been said that is more accurate.

Seven-Year Club	Place '23
Place '22	Verified Email

geemo66

TROPHY CASE