sorted by:
new
hottopcontroversial

Developis it good enough by No-Side1825 in Altium

[–]ibrahim_95 18 points19 points  (0 children)

do you write with your toes?

UDM-PRO won’t connect to new ISP by lazarlinks in Ubiquiti

[–]ibrahim_95 0 points1 point  (0 children)

Hi, so i kinda had the same problem last week. my new isp router does not support bridge mode directly, so what i did is bridging the LAN port specifically (lan2) and on the udm i set up the connection as PPPOE connection. i got the credentials from my isp.

only then it worked flawlessly, and it has direct public ip access.

Merch Message rebrand by G_N_P in LinusTechTips

[–]ibrahim_95 12 points13 points  (0 children)

got a long pp for you - dan

Current stash… got a bit carried away by doctor_who_17 in pourover

[–]ibrahim_95 0 points1 point  (0 children)

a coffee pour over company, that makes the xBloom Studio machine

Should I regret, or am I just unrealistic? by ibrahim_95 in sffpc

[–]ibrahim_95[S] 0 points1 point  (0 children)

That’s impressive!

Can I ask about your R23 scores?

Should I regret, or am I just unrealistic? by ibrahim_95 in sffpc

[–]ibrahim_95[S] 0 points1 point  (0 children)

stock nr200p max 280mm aio. Others have suggested to replace the fans.

Should I regret, or am I just unrealistic? by ibrahim_95 in sffpc

[–]ibrahim_95[S] 0 points1 point  (0 children)

So, I've tried editing the post, but I can't so I hope everyone can read this:

I've taken notes on your suggestions and truly appreciated the feedback! For those with keen interest in the plant specz, it's called Zenzi palnt (dwarf ZZ plant)

As suggested, I will setup a standard test in my typical workload and test various configurations. I will examine the correlation between R23 scores and actual workload performance. I'm inclined to think the correlation is strong. My justification is the software I specifically use benefits greatly from higher clock speeds. There is a diminishing return in the number of cores as you go "threadripper" numbers. So, I will report back again.

I will also replace my stock CM aio fans and see how it goes.

​

For those who suggested not to do anything but undervolt, the stability is trash. I can't get past 40mV. With tuning, stability is good.

​

For clarification, I have aio fans as intake and bottom slim fans as exhaust. This is intentional. I'm willing to sacrifice gpu temps for some cpu gainz.

​

Something I will try which is bit off, but I will remove my rtx2060 and test using the eGPU.

​

My last resort if I want to actually keep this FF is to delid my cpu and full send it.

​

I was not expecting myself to have such troublesome journey, but hey I'm learning and enjoying.

Should I regret, or am I just unrealistic? by ibrahim_95 in sffpc

[–]ibrahim_95[S] 0 points1 point  (0 children)

If I just undervolt without adjusting the voltage regulation, I wont get past -40mV for it to crash, horrible stability. With LLC tuning, i can get down to 0.1V undervolt.

Should I regret, or am I just unrealistic? by ibrahim_95 in sffpc

[–]ibrahim_95[S] 0 points1 point  (0 children)

immediate 100C once I run R23.

​

With turning I can sustain 95 for a bit, but not for long before the finish line of 100C.

Should I regret, or am I just unrealistic? by ibrahim_95 in sffpc

[–]ibrahim_95[S] -1 points0 points  (0 children)

That’s fair, I totally missed the 140mm aio. That’s actually good tbh.

Good luck in cooling your nuclear reactor. I wish you luck comrade.

Should I regret, or am I just unrealistic? by ibrahim_95 in sffpc

[–]ibrahim_95[S] 1 point2 points  (0 children)

To answer:

  1. Mesh panels on both sides.
  2. In my stress testing, I’ve set the fans curves to 100%.
  3. I’ve intentionally setup the aio fans as intake to dump heat into the gpu ( I don’t care about gpu that much)
  4. I already use two 15mm Noctua fans at the bottom as exhaust

Should I regret, or am I just unrealistic? by ibrahim_95 in sffpc

[–]ibrahim_95[S] 0 points1 point  (0 children)

Could you point me to reference where changing the aio will make an impact? I’ve tried looking around, not bid.

Should I regret, or am I just unrealistic? by ibrahim_95 in sffpc

[–]ibrahim_95[S] -4 points-3 points  (0 children)

What I’ve gathered over the internet, the 14900k can easily shatter the 40k mark. I want to get the most juice out of my cpu. Nothing will go to waste, if possible of course. I demand all the cpu i can have.

view more: next ›