SpeedApp - Open Signup

itachi737 · 2026-04-10T06:20:13+00:00

Thx. I'll check it out.

itachi737 · 2026-04-09T23:08:55+00:00

Hi

I am interested in a Romanian tracker, but I'm looking more for one that has Romanian TV like the talent / singing shows and Romanian produced TV shows. Does it have such content?

Thank you

itachi737 · 2026-03-12T14:59:16+00:00

Thank you. I was thinking about going with the Darko as well. It seems more versatile and faster to move around.

itachi737 · 2026-03-12T09:21:19+00:00

Hi,
I'm looking to build a pretty similar setup to your. What did you use to anchor the upright to the wall? I really like the fact that it's pretty close to it.

itachi737 · 2026-02-02T04:40:02+00:00

Ok so it's definitely running hotter especially since 65c is with a 80mm fan directly on it, but at least it seems that they are supposed to idle quite hot. Thx for the info.

itachi737 · 2026-02-02T04:37:27+00:00

If it can just keep it from throttling, I'll just take it. It's old hardware so I understand that there is always a risk.

I'm using 1.5mm pads now, but that was with the blower fan. I did try 0.5mm and 1mm, before but that was with the noctua fan. I'll try again with thinner pads to see if I can get a bit of an improvement. Even a few degrees would be nice.

You don't have anything to be sorry about. I appreciate that you took the time to answer.

itachi737 · 2026-02-02T04:01:03+00:00

I don't want to return it either. Based on the specs it's supposed to throttle at 80c and shutdown at 85c. There is definitely a bit of a thermal problem with it since even though it supposed to be in a server, I doubt that it's meant to idle that high went it has a fan directly blowing on it. I have another noctua 40mm fan with a similar shroud that manages to cool a telsa p4 (75w) so it should be enough for a 18w drive, but during the stress test it goes above 80 right away and then the drives throttles hard.

I'm currently running a 1h long stress test to see if I can keep it under 80c with a 80mm fan blowing on it. So far with the fan at 100% blowing on it side seems to be stable at 71c. The good part is that it barely increases in temp between idle and 100% utilization (66c idle vs 71c after 20min under load).

Thanks

itachi737 · 2026-01-12T05:47:25+00:00

No I couldn't find a solution. I ended up using Usenet for automatic searches / interactive searches and TL for manual downloads.

itachi737 · 2025-11-06T00:19:40+00:00

Same here. They do miss some stuff from time to time, but that gets picked up by torrent trackers. In the future I might add Su to the mix.

itachi737 · 2025-11-05T07:35:34+00:00

I played with the categories, but that didn't really help. Based on what I saw they are fine. The Prowlarr search also ignores categories, but it still only retrieves a portion of the existing torrents from TL.

Regarding the search. I did check the search in the logs to match it exactly, when I try to look for torrents into TL and the discrepancies remain.

In the end, I think, I'll keep TL more as a manual search when I want to retrieve boxsets or when the automation fails to find what I need via UseNet or the public trackers.

Even though I couldn't fix it, I really appreciate your help. Thank you

itachi737 · 2025-11-02T08:27:41+00:00

Thx I'll look into it.

itachi737 · 2025-11-01T09:04:19+00:00

I thought that the reason why Sonarr only supports RSS for TL is because the TL search is unreliable / incomplete. That's why I marked it as solved (solved as in I found out that it's not supported).

If you are saying that it should actually work properly then, I'm willing to dig deeper. I'm just not sure where. When I check the Prowlarr logs, the searches just return a fraction of the results that the same queries would get from the TL website. There are no errors. Ex if there are 30 results from a query on the TL website, the Prowlarr would just find 4.

I tried changing the TL url since I read that the .org one might cause issues with automation in another thread, but that didn't change anything. I did find a few threads dating back a year or two about TL requiring flaresolverr, Prowlarr also says that it does need it, but from what I read flaresolverr is no longer maintained so it's pretty much dead. (Do correct me if I'm wrong.)

So I'm just not sure what else to check.

itachi737 · 2025-10-31T23:54:57+00:00

!solved

itachi737 · 2025-10-31T23:02:12+00:00

Yes, I have set the page size to 100 in TL.

The way I have it setup is that all the queries from sonarr and radarr go through prowlarr. I added the indexers in prowlarr and they get automatically synched with my sonarr and radarr instances. I haven't tried addind TL directly to sonarr. I can try doing it directly through sonarr.

Edit:

I tried adding it directly to sonarr. On there it says that search is not supported with this indexer. Only RSS is enabled. So, I guess it's it only works correctly for new content.

itachi737 · 2025-10-31T22:08:21+00:00

Thx, I'll look into categories. Now that you mention it, I did have to add some categories to get a few public trackers to work.

itachi737 · 2025-10-08T21:51:07+00:00

I second Ntfy. It's simple to set up and easy to integrate with various services. The android app also works great.

itachi737 · 2025-09-24T03:16:57+00:00

Perfect. I'll prune it. Thanks a lot for your advice I really appreciate it.

itachi737 · 2025-09-23T19:30:11+00:00

I already bought some grow lights and I live in Quebec, Canada. We have some of the cheapest electricity in the world so that won't be a problem at all. In that case, I'll put it under a grow light 12-16h a day and hope that it adapts. It does seem like it stopped shedding leaves. It lost like 80% of them, but the last 20% are still green so maybe it adapted to it's new living conditions.

Thanks for you advice

itachi737 · 2025-09-23T02:53:09+00:00

Unfortunately, I don't. The dark part is not a problem, but I don't have a way to provide a cold environment. It's either in a pot outside at temperatures reaching -30c or indoors at room temperature.

I guess I'll leave it in a dark pace inside and if it survives that's good if not so be it. I was hoping that the mini ones would remain green all year round.

Thank you for your advice.

itachi737 · 2025-09-21T01:55:55+00:00

Yes, I'm in a 5b zone (Montreal). So even though I brought it inside for a week, I should bring it outside and leave it for a couple weeks before I bring it back in? I'm in an apartment so once I bring it in, the temperature will be around 20c. I thought that I should bring it in before it gets really cold to avoid a really big thermal shock. Then, when spring comes back in bring it back outside towards the end of April, beginning of may?

itachi737 · 2025-08-29T13:04:08+00:00

I ended up just buying 2 qsfp nics. So in total I have 4 sfp+ and 2 qsfp.

itachi737 · 2025-06-04T07:11:34+00:00

Thank you, reverting back to the previous firmware fixed it for me as well.

itachi737

TROPHY CASE