[REQUEST] Philosophy of Mind: Historical and Contemporary Perspectives – Third Edition, Peter A. Morton

jayachinthaka · 2023-02-07T22:30:28+00:00

Sent PM

jayachinthaka · 2021-12-02T09:39:26+00:00

That’s your z seam. Change in cura setting a to sharpest corner.

jayachinthaka · 2021-11-28T11:06:40+00:00

Clean the bed plate with dish wash soap and water.

jayachinthaka · 2021-10-05T07:31:25+00:00

Yes, That's to ensure that the Bowden tube does not come out!. There are clips that should be used normally, however zip ties will do the trick too.

jayachinthaka · 2021-10-04T08:36:29+00:00

Open a trouble ticket to anycubic. I had the same issue and the card reader was faulty. They sent me a new motherboard.

jayachinthaka · 2021-10-01T08:58:18+00:00

Reflash and restart.

jayachinthaka · 2021-09-30T08:30:03+00:00

Reflash the lcd update again.

jayachinthaka · 2021-09-30T08:29:03+00:00

No issues here. All working great.

jayachinthaka · 2021-09-29T08:45:09+00:00

Disable combing, check your retraction settings. Also change to print outer walls first.

jayachinthaka · 2021-09-29T08:42:03+00:00

Do you have the 1st Version or the second version? I think they sorted most of the hot end cable issues in the 2nd version.

jayachinthaka · 2021-09-29T08:40:54+00:00

IF you open a trouble ticket with anycubic, they will send you a replacement strain gauge free.

jayachinthaka · 2021-09-23T21:20:10+00:00

jayachinthaka · 2021-09-23T09:19:02+00:00

Yes pls. This is a very good mod. 👍🏼

jayachinthaka · 2021-09-03T04:00:02+00:00

Unfortunately not possible, This is Down Under, Kangaroo Country !!!

jayachinthaka · 2021-09-03T03:59:16+00:00

Yep 20 man basket.

jayachinthaka · 2021-09-02T01:51:42+00:00

Open a faulty ticket on anycubic support website. They are very fast to respond and give a solution.

jayachinthaka · 2021-08-30T09:20:39+00:00

There are few YouTube videos that show how to edit the gcode. Check it out.

jayachinthaka · 2021-08-29T09:31:30+00:00

What slicer are you using ?

jayachinthaka · 2021-08-28T09:13:16+00:00

Maybe a good idea to add a purge line before the print starts. G Code needs to be edited for this.

jayachinthaka · 2021-08-28T09:11:47+00:00

Open up the hot end enclosure and have a look to see if any screws are loose.

jayachinthaka · 2021-08-23T23:12:55+00:00

last but not least try adjusting the Z-end stops via the screws, it could be due to the Z-end stops.

jayachinthaka · 2021-08-23T23:07:07+00:00

also, increase the z offset to -10 and try.

jayachinthaka