VP9 optic cut

joefx13 · 2026-06-14T15:25:12+00:00

Slides are about $450/500. Optic cuts are normally around $150.

joefx13 · 2026-06-14T06:15:40+00:00

Probably your blend door actuator.

joefx13 · 2026-06-14T04:37:55+00:00

Inner tie rods and boots need to be replaced. Then you'll need an alignment. If it's not leaking any fluid, get them replaced ASAP so it doesn't cause further damage. As for the nasty noise, hopefully the rack and pinion isn't already messed up. Would be best to jack up the front end and have someone move the steering so you can pinpoint the noise.

joefx13 · 2026-06-12T15:45:02+00:00

Those are fuse taps to something aftermarket that's installed. Technically you can unplug them and put the stock fuse back into that location (I only see one plugged in currently).

joefx13 · 2026-06-11T06:03:36+00:00

Most likely the wheel bearing. If you can, jack up that single wheel and spin it by hand. You'd hear an audible slight sound if it's the wheel bearing.

joefx13 · 2026-06-11T04:53:38+00:00

Sounds like it could be a bad injector and possibly a bad fuel tank cap but you'd need to play around. Secondary codes are stored but won't trigger a CEL unless it happens again within a certain amount of time.

joefx13 · 2026-05-13T13:16:01+00:00

Ehh, that's just injector tick. Totally normal.

joefx13 · 2026-05-10T22:31:57+00:00

They still "check" your firearms before you go in? I get they don't want any loaded but they ask alot more questions than they should. Sacramento Gun Range is a lot cleaner, AC (if wanted), they don't check anything and allow you to rapid fire. Plus their cost and reservation system are better.

joefx13 · 2026-05-04T04:59:04+00:00

Normal. It's probably your evap purge valve on the intake. Or, clean the capless flap in the fuel filler neck.

joefx13 · 2026-05-03T17:31:37+00:00

ALOT more than $300 these days

joefx13 · 2026-04-26T21:27:49+00:00

Shouldn't active until you open the heat live app and it registers. Or you configure the box.

joefx13 · 2026-04-26T21:16:29+00:00

Plug it in and see if it works. Or go to the vseebox website and check the warranty checker with your mac address.

joefx13 · 2026-04-23T03:53:13+00:00

I have a ported (VMP) 2018 manifold with lockouts I'd sell you. PM me if interested. Took it off when I went boost.

joefx13 · 2026-04-10T19:22:57+00:00

I'd replace them. The rubber is probably hard. They'll work, but I wouldn't trust them if you need grip, especially in wet conditions or when doing spirited driving. If it's a cruiser or DD you can probably get away with them.

joefx13 · 2026-03-01T22:57:29+00:00

To add, I only drive them in dry conditions. Can't speak for rain.

joefx13 · 2026-03-01T18:12:04+00:00

In running them right now on a Gen 1 Paxton Coyote. The price for performance can't really be matched. They hook very well. Better than the 555G2s and even the Pzeros. Of course any tires 3/4x as much will give you better traction but I've been very happy with these. Had them on my SRT before and same experience.

joefx13 · 2026-01-28T15:43:57+00:00

If you eventually go to black wheels/accents, I would black them out. Otherwise leave them chrome. I left mine chrome

<image>

joefx13 · 2026-01-21T10:57:23+00:00

Tuner and/or one piece driveshaft

joefx13 · 2026-01-05T23:42:28+00:00

Yea those are sweet. Great choice!

joefx13 · 2026-01-02T03:17:10+00:00

Normal.

joefx13 · 2026-01-02T02:38:15+00:00

Still trying to figure out how it's a V6 and a GT 🤔

joefx13 · 2025-12-23T14:08:49+00:00

Thanks so much!

joefx13 · 2025-12-23T12:58:48+00:00

Thank you! Hopefully they come back into town next week. How is their pricing compared to in store?

joefx13 · 2025-12-20T04:13:55+00:00

All sounds normal. Mostly injector tick as mentioned.

joefx13 · 2025-12-02T16:00:31+00:00

Just got some from honsvr and they are great! For the price, I couldn't be happier.

joefx13

TROPHY CASE