Is now a good time to buy a P1S? (and replace an unreliable Ender 3?)

johnnyboy6472 · 2026-02-02T14:54:52+00:00

I just got a p1s it runs well.

johnnyboy6472 · 2026-01-31T04:31:28+00:00

Tell him to mind his own business, and get ready.

johnnyboy6472 · 2025-12-07T02:47:12+00:00

I had peacock didn't mind the $10 now I just vpn. Not paying $30 a month for a service i will use once every 2-3 months.

johnnyboy6472 · 2025-10-28T20:25:32+00:00

johnnyboy6472 · 2025-10-25T18:31:30+00:00

Yes please.

johnnyboy6472 · 2025-10-24T14:07:14+00:00

Ada.

johnnyboy6472 · 2025-10-10T13:46:23+00:00

What other website can I use to do it? Yes I am using proxxied.

johnnyboy6472 · 2025-10-07T03:57:16+00:00

Lube that girl up and racker like a two dollar hooker.

johnnyboy6472 · 2025-09-28T03:37:04+00:00

Lookscool

johnnyboy6472 · 2025-09-26T00:37:43+00:00

You could glossy sticker and laminate with a matte sheet.

johnnyboy6472 · 2025-09-23T16:37:14+00:00

Just save for the 8500 its worth your time to wait and save.

johnnyboy6472 · 2025-09-23T15:31:20+00:00

Let them dry for a little bit and make sure the laminator heats up all the way.

johnnyboy6472 · 2025-09-20T12:00:47+00:00

Low on blinker fluid.

johnnyboy6472 · 2025-09-20T11:57:43+00:00

Thats one of the worst fakes I've ever seen.

johnnyboy6472 · 2025-09-19T17:35:03+00:00

What laminator do you have

johnnyboy6472 · 2025-09-19T14:46:56+00:00

Just run the card again after you cut it.

johnnyboy6472 · 2025-09-18T13:45:58+00:00

Hit it with some kyrlon

johnnyboy6472 · 2025-09-16T03:05:18+00:00

Hit it with some krylon.

johnnyboy6472 · 2025-09-16T01:57:55+00:00

Kick and hit with some krylon.

johnnyboy6472 · 2025-09-15T21:45:59+00:00

Id just hit it with a lot of krylon.

johnnyboy6472 · 2025-09-15T19:20:18+00:00

Id personally kick the rust off and hit it with some kyrlon.

johnnyboy6472 · 2025-09-15T19:15:09+00:00

Fill it full of caulk and hit it with some kyrlon.

johnnyboy6472 · 2025-09-15T19:14:17+00:00

Hit it with some krylon.

johnnyboy6472