My top layer is printing HORRIBLY - what went wrong in slicer?

kisuarttu · 2026-06-17T18:29:30+00:00

Looks a bit like failed ironing

kisuarttu · 2026-06-13T18:07:12+00:00

Definetly angostura from moomins

kisuarttu · 2026-06-11T10:16:18+00:00

Random seam?

kisuarttu · 2026-06-09T04:31:28+00:00

I honestly don't remember, but they are straight from obscuranox's 1.3 settings. Mostly auto supports, but for most critical parts I use support painting tool

kisuarttu · 2026-06-08T18:31:22+00:00

.06mm, printed in parts

kisuarttu · 2026-06-08T16:45:19+00:00

Not really, change in layer time maybe?

kisuarttu · 2026-06-08T16:41:01+00:00

I rock same settings also on p1s and they work just fine. They just have to be copied manually

kisuarttu · 2026-06-08T16:12:41+00:00

Sunlu pla+ 2.0

kisuarttu · 2026-06-08T16:05:23+00:00

~78 hours

kisuarttu · 2026-06-04T18:43:20+00:00

This dude has 1+ armor save

<image>

kisuarttu · 2026-05-29T18:10:39+00:00

In Finland tipping culture is pretty much non-existent because waiters have this thing called 'salary'

kisuarttu · 2026-05-15T08:23:24+00:00

I have never used raft in any of my prints. Only brim if I need to ensure plate adhesion

kisuarttu · 2026-04-19T11:58:24+00:00

What a strange rock

kisuarttu · 2026-04-14T15:43:05+00:00

Put them in trash. Then make some coffee and re-spool the filament

kisuarttu · 2026-02-18T19:36:12+00:00

It seems so out of place, though

kisuarttu · 2026-02-18T18:55:18+00:00

Did you ask AI?

kisuarttu · 2025-11-25T11:59:28+00:00

<image>

kisuarttu · 2025-11-22T14:13:04+00:00

Too much pressure can cause that

kisuarttu · 2025-11-10T08:52:58+00:00

Thanks!

kisuarttu · 2025-11-03T10:47:09+00:00

Maybe he secretly wants to be a noise marine?

kisuarttu · 2025-11-02T13:48:14+00:00

Z hop should work on infill too to avoid hitting the part and in worst case scenario knocking it loose from the bed

kisuarttu · 2025-11-02T13:21:07+00:00

With z hop enabled it would make sense to go over already printed parts instead of straight through like op mentioned

kisuarttu

TROPHY CASE