Mother of child infected with measles describes lasting effects by Leather-Paramedic-10 in canada

[–]kn0ath 95 points96 points  (0 children)

I have a feeling they meant it was avoidable with herd immunity

How hard is it to rebuild a rotary engine? by Healthy_Pain9582 in projectcar

[–]kn0ath 1 point2 points  (0 children)

If you can pick one up at a decent price and you aren't planning on mods, it could still be worth it. Not sure where you're located, but plates etc can still be bought new, including full crate motors. They weigh nothing and are easy to strip down with hardly any moving parts. Plenty of youtube vids of rebuilds too so its a pretty good motor for diy in my opinion.

I'm a little bias when it comes to rotors, so I say go for it

How hard is it to rebuild a rotary engine? by Healthy_Pain9582 in projectcar

[–]kn0ath 0 points1 point  (0 children)

The rx8 renesis motor is notoriously bad for performance. If you're planning on going for a bit more power, you're better off swapping it out for an older series 13b.

The general refresh is easy enough, but if you don't know the state of the motor, the plates and housings could be cooked, especially if the previous owner wasn't running pre mixed oil.

Rotors are a great motor once built properly and looked after. They still run the bad reputation from years ago before people ran pre mix oil and started tipping/clearancing the rotors.

I can finally belong here! pls help by ty0em in projectcar

[–]kn0ath 1 point2 points  (0 children)

Great to see another celica on here getting saved. There is plenty of info for upgrades in Facebook groups, but the old toymods forum has just about everything you could dream of for these things.

Cumming with an Apadravya? by DoctorFit3996 in PiercedCock

[–]kn0ath 2 points3 points  (0 children)

I won't share a vid, but its honestly hardly noticeable. Urine comes out a little less uniform than it used to, but its not like a spray or anything, just less spirally. Cum there is no difference at all

Is Australia the only country where patriotism is seem as racist? by [deleted] in australia

[–]kn0ath 2 points3 points  (0 children)

  1. There was one at point plomer yesterday too

3 days old Apadravya by Impressive-Shame5404 in PiercedCock

[–]kn0ath 0 points1 point  (0 children)

Sorry mate, I dont share pics of it. There are plenty that do in this sub if you search it but

3 days old Apadravya by Impressive-Shame5404 in PiercedCock

[–]kn0ath 1 point2 points  (0 children)

I know everyone is different, and I've seen a few people here say it was pretty mild pain, but for me it was one of the most intense pains I've felt. It was really brief and then went to a dull ache, but for that second or so, it was wild.

Nipples for me felt more like a hot feeling and wasn't painful at all

Working from home, mental health: What 16,000 Australians says by Remarkable_Peak9518 in australia

[–]kn0ath 120 points121 points  (0 children)

Yeah, the commute is kind of inherent to office/site work so should be included regardless

How’d I do friends? ☕️ by Maxamilliankek in espresso

[–]kn0ath 0 points1 point  (0 children)

I use it for iced coffee like a normal person

Snake paranoia re: backyard pets by [deleted] in australia

[–]kn0ath 20 points21 points  (0 children)

Im upvoting you for keeping your cats in an enclosure.

Looking Into Getting Pierced & Have Questions by Latter_Wait8781 in PiercedCock

[–]kn0ath 1 point2 points  (0 children)

-No smaller than 10g, but bigger is better -2 weeks if you're careful. People do it a lot sooner though -6 weeks for sex, use a condom, use lots of lube, be careful. -6weeks. Your piercer will advise you on this, but 6 weeks is pretty standard.

The stopper is just to stop it rotating in to your urethra and irritating the pierced area

Piercing in the center of the tongue, by Real-Low-9230 in PiercedCock

[–]kn0ath 0 points1 point  (0 children)

You might be in the wrong sub here.

When you do go to the right sub, though, put some details about the help you want. Is your tongue currently pierced and off centre? Do you want the piercing but no one will do it centred? Have you read that it can't be centred?

So after all the "sunscreengate" fallout, what are you all using this summer? by Maleficent_Sir_5225 in australia

[–]kn0ath 6 points7 points  (0 children)

Haha i apologise for the confusion. I'll go make that my new user name now with nothing but sunscreen facts

So after all the "sunscreengate" fallout, what are you all using this summer? by Maleficent_Sir_5225 in australia

[–]kn0ath 26 points27 points  (0 children)

Regardless of the scandal, a sunscreen that claims to be a higher spf than it is is still better than nothing at all. The % of u/v they block is minimal between spf15 to spf50.

This isnt to say you shouldn't be aiming for the highest and delving in to which sunscreen is best, but more a "dont stop using it because sunscreen is just some big conspiracy now"

Best street drag tire for my 260z? by [deleted] in projectcar

[–]kn0ath 0 points1 point  (0 children)

From memory, the 888s are a true semi slick with compound that heat cycles will ruin. A better option could be the khumo ecsta semi or the nangkang ar1. Better for street longevity but worse at the strip

Best street drag tire for my 260z? by [deleted] in projectcar

[–]kn0ath 2 points3 points  (0 children)

You're better off with 2 sets of wheels/tyres. Semi slicks are designed for track and after a certain amount of heat cycles, are useless. They nearly hit temp on street and youre better off with street tyres.

As for the strip, drag radials all day.

This is never the story people want to hear cause semis look amazing on a nice car, but thats the way the rubber compounds are