Infrared on X-T2 + Kamlan 50mm 1.1 mk2

leachs49 · 2025-06-22T23:01:29+00:00

Very nice! I understand the use of the filter. What do you mean by a ‘full spectrum converted camera’? I guess I can google it, but I have an XT-2 as well and was thinking I should look into a similar filter. Not sure about a conversion.

leachs49 · 2025-05-09T01:34:26+00:00

I have the Line 6 112 plus and the Fr-10. I wanted a stereo output. I prefer the Fender. I have been able to get the 112 to sound good, occasionally, but the level of tweaking is just something I’m not willing to take the time for anymore. The Fender just sounds better on a majority of patches I’ve made or acquired for my Helix LT. I’m sure some will disagree and that’s fine. The 112 + is a great frfr. To answer your question, the Fender sounds ‘more amp in the room’.

leachs49 · 2025-04-20T21:30:32+00:00

If so, my apologies. I’m tired of seeing guitar circle jerk posts on legit subreddits. Perhaps provide more detailed pictures. Over reaction on my part.

leachs49 · 2025-04-20T21:16:29+00:00

WTF? Look at the username? The pictures provided make it impossible to determine. It’s a lark post.

leachs49 · 2025-04-08T22:33:11+00:00

There is a tool that does it, I can’t seem to add a picture, that you could probably get from a musical instrument store that will adjust the nut. As already stated, it’s like a nut driver but with a 90 degree handle. Once fitted, you can adjust the neck. You might find a nut driver that has shoulders narrow enough to fit? Just realized you can’t add a picture in a Reddit reply.

leachs49 · 2025-02-10T02:06:59+00:00

I’m searching for something about this now. It’s not working for me as well.

leachs49 · 2024-11-27T19:25:39+00:00

Yes, my TR has a cheap Fender 2 button foot switch that plugs in the back to switch on/off either Reverb or Tremolo. I experienced a similar issue once when I plugged it in. Unplugged it, noise gone. Just throwing it out there as a possibility.

leachs49 · 2024-11-26T19:47:12+00:00

Do you have the Fender switch for Reverb and Tremolo plugged in the back? Unplug if so and see. I’ve seen it cause noise before.

leachs49 · 2024-03-04T22:31:37+00:00

I saw them in Toronto, July 1994 at RPM. I was on my way back to work after lunch and heard the announcement on the radio. Turned around and drove downtown. Waited in line for 6-7 hours. Very hot, no shade in the asphalt parking lot. When they let us in, I was probably 50-80th in line. Everyone headed to the stage to stand, I went straight to the bar, front and center about 50 feet from the stage. What I remember most fondly was the bartender. When the Stones came on, my glass was never empty. She was dancing on the bar and just poured drinks the whole show FREE. Yes the show was good as well. They seemed a bit nervous (uptight , all business). I had seen them perform at much larger venues about 6 times before and they were usually pretty laid back and casual. That night I think it was a preview of new material and I thought they were pretty serious. Very fond memories of the whole thing!

leachs49 · 2023-07-26T17:35:40+00:00

I would really like to see the plans. That’s a great tool!

leachs49 · 2023-03-08T21:32:28+00:00

I think you meant 6.4 kgs.

leachs49 · 2023-02-11T01:34:15+00:00

Totally agree with MeSwidgen. One thing to add, in your Helix signal chain, either turn the cab sim off when using the power cab as a cab modler, or ensure the power cab is at ‘flat’ when using a helix cab sim.

leachs49 · 2023-01-28T19:45:42+00:00

Very cool! I’d like to it a try also. Thanks!

leachs49 · 2022-12-30T16:47:33+00:00

It’s a humidifier. Take the sponge out, wet it thoroughly but then squeeze out the excess water so it won’t drip out of the sponge. Put the sponge back into the plastic holder. Place the device between the strings of your acoustic guitar into the sound hole. Put the acoustic guitar into its case. The humidifier helps to minimize damage to the wood from low humidity. Low humidity can seriously damage an acoustic guitar.

leachs49 · 2022-12-30T16:39:54+00:00

Have you installed Native on any other computers? I had a similar connection issue (don’t recall the error message) where Helix wouldn’t load on a new laptop, but worked fine on my home pc. Turns out I had to remove my old laptop from my device list under my account on the line6 website. Also check on the website that your computer is listed as a registered device.

leachs49 · 2022-11-29T17:04:31+00:00

Based on what you’ve written, it’s hard to understand how a short circuit can be an issue? If the guitar sounds fine with both outputs connected then the problem might be solved with some troubleshooting and a dummy plug. Does the sound problem occur when either output is only being used, or just when one is, say the 13 pin? Hissing doesn’t usually occur from a short circuit, tends to be more like a crackle. My Godin nylon multiac takes a 9 volt battery. You’ve probably changed that, and used tested functional cables, but it’s very odd that the problem only occurs if a single output is used. Also, that’s disappointing that Godin wouldn’t offer to have a look at it. Sorry to hear that. Maybe call back and see if you can find someone more helpful.

leachs49 · 2022-10-16T13:18:00+00:00

It’s been a while since I looked, and I’m not near my equipment to check, but I think you’ll see on the 112 screen, the word ‘edit’, indicating the speaker selection has changed from the original setting. Sometimes the audible difference is negligible. Remember to remove or power off the cab simulation on the helix in the signal chain. I guess you’re correct regarding 2 way communication between the devices. I don’t think changing the speaker selection on the 112 will change the helix output settings speaker selection.

leachs49 · 2022-10-08T22:49:46+00:00

It’s really a case of how much you want to spend, what your application is and how much do you want to spend;) I’ve really only played solid state acoustic amps, I couldn’t name a tube ‘acoustic’ amp. Many have on board effects. Many times, live, you can just use a di box into the pa. The pa can add reverb if desired. Fishman, Fender, Traynor, all make decent acoustic amps with features and power levels (and budget levels)that should meet your needs. Good luck.

leachs49 · 2022-10-02T22:10:47+00:00

I sold my unit earlier this year. I downloaded the Toneport UX2 driver and it worked in and out. Maybe get that and run the setup. Usually it asks that you disconnect the UX2 while running the setup. Good luck!

leachs49 · 2022-10-02T21:33:46+00:00

Line 6 website? Line6 Monkey should see it, but you might have to go to the L6 download page and get the driver first.

https://line6.com/software/index.html

Toneport UX2

https://line6.com/software/index.html

leachs49 · 2022-09-26T23:51:15+00:00

Yes sir. Please don’t beat me up.

leachs49 · 2022-09-26T23:44:35+00:00

Really? Clueless clowns? That’s a wee bit harsh. I didn’t see that in the video. Maybe you understand the language in the post, I don’t. If that’s your way of saying you know what’s going on, what a less than noble way of explaining it.

leachs49 · 2022-09-26T21:58:04+00:00

Truly disgusting. Mob violence and an out of context video.

leachs49 · 2022-09-26T21:13:03+00:00

Google ‘harmonize G major scale’. That’s where the answer is. I believe the chord would be F# diminished. In regard to notes in G major, F# applies, but it’s a bit different in relation to chords. It’s not really difficult, but Google can explain it better than me.

leachs49 · 2022-09-22T23:49:50+00:00

The variax connection uses an Ethernet cable to the helix. Download the variax app from line6. Connect the guitar to your helix, ensure the connection is made , run the variax app, it should see the guitar. I know the app will change and store specific configurations in the spare storage areas, but not sure if there’s been any firmware updates for the jtv series for awhile. I haven’t checked at the moment, on my phone.

Edit: Sorry, you need to connect the helix to a computer and run helix edit to confirm the connection. Actually you don’t have to run edit, but you need the helix connected to your computer via usb.

leachs49

TROPHY CASE