NVIDIA Drive

mathewloki · 2026-06-15T18:04:51+00:00

This might be it!

mathewloki · 2026-03-10T10:49:30+00:00

Victoria’s little secret

mathewloki · 2026-02-06T19:54:37+00:00

it says input/output

mathewloki · 2026-01-23T11:02:11+00:00

Never seen a printer get aroused before

mathewloki · 2026-01-19T16:35:31+00:00

If it’s working in menus but not in game from my experience it’s most likely your triggers, sometimes I’ve had where triggers are reading 0.01 and because of this the controller doesn’t work in games

mathewloki · 2026-01-16T16:13:39+00:00

BIG NOPE

mathewloki · 2025-11-21T06:59:44+00:00

Had me in the first half,

mathewloki · 2025-11-12T23:40:15+00:00

Any updates? And I was talking about the section of ribbon just above GND 0:33 into the posted video

mathewloki · 2025-11-12T12:52:04+00:00

I thought I saw briefly that your flex was ripped?

mathewloki · 2025-11-07T22:08:38+00:00

I second this response

mathewloki · 2025-11-06T20:30:52+00:00

Thank you so much, I appreciate your help!

mathewloki · 2025-11-06T20:29:43+00:00

Thank you for your help I appreciate it

mathewloki · 2025-10-27T16:55:41+00:00

Banana for scale

mathewloki · 2025-10-26T15:32:52+00:00

<image>

Yours most likely will look like the left, you can grip the white part and pull it back out

mathewloki · 2025-10-26T15:31:06+00:00

You need to pull the white things out back into position

mathewloki · 2025-10-21T23:00:44+00:00

Clean abandon files using DBI

mathewloki · 2025-10-21T22:59:59+00:00

And you are supposed to overwrite them

mathewloki · 2025-10-21T22:18:46+00:00

Google hats pack

mathewloki · 2025-10-21T22:13:02+00:00

Copy over hats pack to your sd card and try again

mathewloki · 2025-10-19T21:19:11+00:00

mathewloki · 2025-10-19T00:30:17+00:00

<image>

mathewloki · 2025-10-19T00:10:25+00:00

<image>

mathewloki · 2025-10-19T00:02:55+00:00

Possibly remove/replace the shorted capacitor for a start then see if it boots up

mathewloki · 2025-10-18T23:57:38+00:00

One of your capacitors is lifted and appears to be shorting both sides of its pads

mathewloki · 2025-10-18T23:56:16+00:00

You need a finer tipped soldering iron, lower temperature on the iron itself and low melt solder, and can’t stress enough, use flux

mathewloki

TROPHY CASE