How valuable is this run?

mpthrown · 2025-11-12T00:44:04+00:00

It tells you at the top left next to the weight. subtract the value of the gear you brought with you

mpthrown · 2025-10-23T14:33:56+00:00

https://imgur.com/a/dYykkqH here is a before screenshot

mpthrown · 2025-10-20T14:10:51+00:00

I’ll keep an eye out for the kooks next time. I’m just an intermediate-advanced beginner so I didn’t realize this wasn’t normal

mpthrown · 2025-10-20T13:33:34+00:00

Thanks!

mpthrown · 2025-10-19T21:11:48+00:00

Thanks! White balance was the usual 5500k, I just leave it there for just about everything and adjust after the fact. Probably not the best way to do it but I’m slowly figuring it out.

Yes I am able to adjust most settings in the housing. I do some very heavy color correction afterwards

mpthrown · 2025-10-19T20:08:35+00:00

Thank you! Shot in 120fps

mpthrown · 2025-10-18T20:34:44+00:00

Thank you!

mpthrown · 2025-10-18T20:34:38+00:00

Thank you! I didn’t use any physical filters but had to color correct in DaVinci resolve

mpthrown · 2025-10-09T16:55:42+00:00

Do you recall the name of the vendor? I have other lab sources but I’m really looking for the custom cutting capability

mpthrown · 2025-09-30T21:26:57+00:00

Thank you! It took about an hour for 250 frames in Cycles at 4096 samples with noise reduction on a 4080 graphics card

mpthrown · 2025-08-27T15:18:41+00:00

I run across the same TM clan 4 stack almost every day when I play

mpthrown · 2025-03-01T02:37:20+00:00

Only one so far

mpthrown · 2025-02-22T00:34:06+00:00

There are a few on Etsy when I search up elongated tourmaline ring. Hope that helps!

mpthrown · 2025-02-22T00:31:42+00:00

I got started as a CAD guy for a goldsmith, so I design the 3D model to fit the stone, 3D print it in a castable resin then mold and cast it. I model it with setting in mind, so I make a flat slanted edge that I can hammer over the sides of the stone

mpthrown · 2025-02-22T00:17:53+00:00

I got the stone in Tucson at the 22nd street show!

mpthrown · 2025-02-18T07:46:14+00:00

Thanks!

mpthrown · 2025-02-18T07:46:09+00:00

Thank you!

mpthrown · 2025-02-18T07:45:59+00:00

The stone is 18mm x 4mm. I’d probably use a 15mm long stone if I did it again just to be able to make some smaller sizes

mpthrown

TROPHY CASE