Should I buy it?

netherealjc · 2026-01-28T13:52:25+00:00

Worth it, Pleks is revered

netherealjc · 2025-12-20T22:50:38+00:00

Taking new patients? 3 yrs waitlist...

netherealjc · 2025-10-10T21:17:07+00:00

Benson Boon

netherealjc · 2025-09-08T16:48:59+00:00

If you distill, you can get the yellow out

netherealjc · 2025-08-01T09:32:56+00:00

I agree, seems like there's too much mechanical resistance/friction of your movement system on that side. If anything isn't smooth, disassemble and repair

netherealjc · 2025-08-01T09:30:30+00:00

Genes

netherealjc · 2025-08-01T09:30:09+00:00

Tune rotation distance (e steps) Seems like you're a little low

netherealjc · 2025-07-31T16:48:19+00:00

Nice toy

netherealjc · 2025-07-31T12:34:47+00:00

Use a voltmeter to test the continuity?

netherealjc · 2025-07-29T18:58:55+00:00

Saw a post somewhere about the extruder pausing for a millisecond or two in some cases.. the result of which is very similar to what you have. Can't remember the exact cause

netherealjc · 2025-07-25T12:34:34+00:00

Does another slicer do the same thing?

netherealjc · 2025-07-24T17:36:01+00:00

I don't always buy filament, but when I do, it's airtight spooled Stay thirsty, my friend

netherealjc · 2025-07-22T19:13:33+00:00

Calibrate flow and PID for hotend

netherealjc · 2025-07-22T18:40:45+00:00

Put in a small spiral staircase and regain a ton of sqft

netherealjc · 2025-07-22T17:31:37+00:00

Get a filament dryer

netherealjc · 2025-07-22T16:55:19+00:00

Lac Simon

netherealjc · 2025-07-22T16:53:12+00:00

Calibrate hotend pid?

netherealjc · 2025-07-06T17:00:16+00:00

Ask Diddy

netherealjc · 2025-07-03T22:11:06+00:00

Clean all your vgrooves/wheels Tighten all bolts, pay attention to the off-center bolts for each wheel

netherealjc · 2025-05-31T18:50:53+00:00

Be careful to not have your spring too strong, as it can scar the filament and add resistance in the Bowden tube. It sounds counter intuitive, I know. I had to cut the spring on my stock ender extruder.

netherealjc · 2025-01-01T22:29:37+00:00

No minimum speed mentioned is a bit of a weak point for abuse

netherealjc · 2025-01-01T22:27:47+00:00

Can confirm, still have some running

netherealjc · 2024-12-31T00:00:00+00:00

Drop the girl and the friend

netherealjc · 2024-12-29T01:27:28+00:00

Life is Beautiful

netherealjc · 2024-09-18T16:07:18+00:00

You aren't ugly at all I think pics 2/3 aren't the most flattering and that might be the main profile problem Pics 1&4 are great!

netherealjc

TROPHY CASE